Whirlpool AKR 416 NB Program Chart

Tipo
Program Chart
5019 100 75152
AKR 410-412-413-415-416-610-611
AKR 612-613-615-616 / AKG 957
INSTALLATIONSANGABEN
Mindestabstand zur Kochfläche: 60 cm (Elektrokochplatten), 70 cm (Gas -, Öl -
oder Kohlekochplatten). Folgen Sie bei der Installation der Nummerierung
(1
Ö
2
Ö
3
Ö
.....). Das Gerät darf erst nach erfolgter Installation an die
Stromversorgung angeschlossen werden. Sollte eine unzugängliche Steckdose
verwendet werden, ist ein normgerechter, zweipoliger Schalter mit einem
Mindestabstand der geöffneten Kontakte von 3 mm in einer leicht zugänglichen
Position anzubringen.
INSTALLATION SHEET
Minimum height above cooker: 60cm (electric cookers), 70cm (gas, gas oil or coal
cookers). To install follow points (1
Ö
2
Ö
3
Ö
.....). Do not connect the appliance to
the electrical power supply until installation is completed. If the plug is not easily
accessible once inserted into the socket, a two-pole switch with minimum break
distance between contacts of 3 mm must be fitted at an easily accessible point.
FICHE D'INSTALLATION
Distance minimale par rapport à la cuisinière: 60 cm (cuisinière électrique), 70 cm
(cuisinière à gaz, mazout ou charbon). Pour le montage, suivez la numérotation
(1
Ö
2
Ö
3
Ö
.....). Ne branchez pas l'appareil tant que l'installation n'est pas
terminée. S'il s'avère difficile d'accéder à la prise de courant une fois qu'elle a été
insérée dans la fiche, installez un interrupteur bipolaire conforme facilement
accessible ayant une ouverture minimale de 3 mm entre les contacts.
INSTALLATIESCHEMA
Minimum afstand van het kooktoestel: 60cm (elektrische kooktoestellen), 70 cm
(kooktoestellen op gas, olie of kolen). Volg voor de montage de nummering
(1
Ö
2
Ö
3
Ö
.....). Geef het apparaat geen stroom totdat de installatie geheel voltooid
is. Als de stekker, wanneer hij in het stopcontact gestoken is, zich niet op een
toegankelijk punt bevindt, moet hoe dan ook een genormaliseerde tweepolige
schakelaar worden gemonteerd met een afstand tussen de contacten van
minstens 3 mm, die goed toegankelijk is.
FICHA DE INSTALACIÓN
Distancia mínima de los quemadores: 60 cm (quemadores eléctricos),70 cm
(quemadores a gas, gasóleo o carbón). Para el montaje, seguir la numeración
(1
Ö
2
Ö
3
Ö
.....). No enchufar el aparato hasta que su instalación no esté terminada.
Si la clavija no se encuentra en un punto accesible una vez enchufada, se deberá
aplicar un interruptor bipolar según las normas con una distancia de abertura
entre los contactos no inferior a 3 mm, que naturalmente deberá ser accesible.
FICHA DE INSTALAÇÃO
Distância mínima dos fogões: 60 cm (fogões eléctricos), 70 cm (fogões a gás,
óleo ou carbono). Para montar siga a numeração (1
Ö
2
Ö
3
Ö
.....). Não ligue o
aparelho à corrente eléctrica até a instalação estar concluída. Inserida a ficha na
tomada, caso não seja fácil o acesso à mesma, deve ser aplicado um interruptor
bipolar, com distância mínima entre os contactos de 3 mm, num ponto de fácil
acesso.
SCHEDA INSTALLAZIONE
Distanza minima dai fuochi: 60cm (fuochi elettrici), 70cm (fuochi a gas, gasolio o
carbone). Per il montaggio seguire la numerazione (1
Ö
2
Ö
3
Ö
.....). Non dare
corrente all’apparecchio finché l’installazione non è totalmente completata. Se la
spina, una volta inserita nella presa, non si trova in un punto accessibile, si dovrà
comunque applicare un interruttore bipolare a norme con una distanza dei
contatti in apertura non inferiore a 3 mm, chiaramente accessibile.
ùüùü+ùùùþ
ü$12.)12.1.)2"0120"FP02!"0120"FP0120"
.0! #02!0. #0! # +.22  21.  #1202
.!1
Ö
Ö
Ö
2! 3 / 2020002!)!0*.21#10#!
2  !&12"0.212.1"ù2 3"0221*/0112!./0
!102.101000* !)1.1!0.2  020/ )"
/.)2"102&. 1+00$12.)12.1. .2 "02.*2&
0.3+PP100* .! 1011
D
GB
F
NL
E
P
I
GR
5019 100 75152
AKR 410-412-413-415-416-610-611
AKR 612-613-615-616 / AKG 957
5019 100 75152
AKR 410-412-413-415-416-610-611
AKR 612-613-615-616 / AKG 957
1.
Control panel.
2.
Grease filters (behind the extractor grille).
3.
Lighting unit.
4.
Pull-out steam deflector
(not extractable on AKR 610
).
REPLACING BULBS
1.
Unplug the appliance or disconnect the mains
power supply.
2.
Pull out the steam deflector
(a-Fig. 1)
.
3.
Open the extractor grille
(b,c,d-Fig. 1)
.
4.
Remove the burnt-out bulb. Replace using
40W max E14 bulbs only.
5.
Refit the extractor grille.
FITTING OR RENEWING THE CARBON
FILTER:
1.
Unplug the appliance or disconnect the mains
power supply.
2.
Pull out the steam deflector
(a-Fig. 1)
.
3.
Open the extractor grille
(b,c,d-Fig. 1)
.
4. Rectangular or circular carbon filter:
Circular carbon filter - Fig. 2:
Assembly:
Fit the carbon filter over the motor
protection grille - The reference mark on the
edge of the carbon filter
(e)
must align with
the arrow on the fan shroud
(f)
, lastly turn
clockwise.
Disassembly:
Turn anticlockwise.
Rectangular carbon filter - Fig. 3:
Assembly:
(g)
Locate the carbon filter on the
back rings and
(h)
secure the carbon filter in
front with the clips provided.
Disassembly:
Press the release buttons
(f-Fig. 2)
and pull the filter downwards.
5.
Refit the extractor grille.
REMOVING AND RENEWING OR
CLEANING THE GREASE FILTER:
1.
Unplug the appliance or disconnect the mains
power supply.
2.
Pull out the steam deflector
(a-Fig. 1)
.
3.
Open the extractor grille
(b,c,d-Fig. 1)
.
4.
Remove the device securing the grease filter.
5.
Remove the dirty grease filter.
6.
After the grease filter has been replaced or
cleaned (depending on model), refit the parts
in reverse order, making sure the entire
extraction surface is covered.
CONTROL PANEL
A.
Light switch.
B.
Speed selector switch.
FIG.1
FIG.2
FIG.3
medium amount of
steam and fumes
F NL E P
GB
D IGR
PRODUCT
SHEET
small amount of steam and fumes
large amount
of steam and
fumes
  • Page 1 1
  • Page 2 2
  • Page 3 3

Whirlpool AKR 416 NB Program Chart

Tipo
Program Chart

in altre lingue