NutriBullet Magic Bullet Guida utente

User Guide

1

Important Safeguards

Warning! To avoid the risk of serious injury, carefully read

all instructions before operating your Magic Bullet®. When

using any electrical appliance, basic safety precautions

should always be observed, including the following

important information.

Save These Instructions!

FOR HOUSEHOLD USE ONLY

GENERAL SAFETY

INFORMATION

• This appliance shall not be

used by children. Keep the

appliance and its cord out of

reach of children.

• Children shall not play with

the appliance.

• Appliances can be used by

persons with reduced physical,

sensory or mental capabilities

or lack of experience and

2

knowledge if they have

been given supervision or

instruction concerning use of

the appliance in a safe way

and if they understand the

hazards involved.

• NEVER LEAVE THE MAGIC

BULLET® UNATTENDED

WHILE IT IS IN USE

• Do not use your Magic

Bullet® for anything other

than its intended use.

HEAT & PRESSURE SAFETY

Do not blend hot or

carbonated ingredients!

• Never put hot or carbonated

ingredients in any of the cups

before or while blending.

Heated ingredients can

cause pressure to build up

in the sealed cup, causing

possible expulsion of hot

ingredients which may cause

personal injury or property

damage. Start with room

temperature or cooler

ingredients (21°C/70°F

or cooler).

• To prevent overheating and

pressure build up, never

allow the Magic Bullet® to

run more than one minute

at a time. Ingredients can

overheat, building pressure

inside the cup that may

3

cause the cup to burst,

which may result in possible

personal injury or property

damage.

• Never blend carbonated

liquids or eervescing

ingredients (e.g., baking

soda, baking powder, yeast,

cake batter, etc.). Built-up

pressure from released gases

can cause the cup to burst

resulting in possible personal

injury or property damage.

If the machine is left to run

for longer than a minute,

friction from the rotating

extractor blades can heat

ingredients and build

pressure inside of the sealed

cup. If your cup is warm to

the touch, stop the machine

immediately and allow cup

to cool completely. To open,

point the cup away from your

body and slowly untwist the

lid.

• After blending ingredients,

allow the contents to settle

and release any pressure that

may have built up during the

extraction process by slowly

unscrewing the cup from the

blade assembly. Point the cup

away from you as you open

it, in case there is any built-up

pressure.

4

• If the motor stops working,

unplug the motor base and

let it cool down for at least 15

minutes before attempting

to use it again. Your Magic

Bullet® has an internal

thermal breaker that shuts

o the unit when it overheats.

Letting the thermal breaker

cool down will allow the

motor base to reset.

• Do not allow blended

mixtures to sit in a sealed

cup for long periods of

time! Sugar in fruits and

vegetables can ferment,

causing pressure to build up

and expand in the cup. This

can cause ingredients to burst

and spray out when moved

or opened.

• Caution must be observed if

hot liquid is poured into the

blender as it can be ejected

out of the appliance due to

sudden steaming.

CROSS BLADE SAFETY

Cross blades are sharp!

Handle carefully.

Use care while handling the

cross blades. Do not touch

the cross blade edges to

avoid injury.

WARNING!

5

Caution must be observed

when emptying vessels and

during cleaning.

AVOID CONTACT WITH

MOVING PARTS! To reduce

the risk of severe personal

injury, keep hands and utensils

out of and away from the

cross blade while blending

food. To reduce risk of

personal injury or property

damage, make sure the

cross blade is securely

hand-tightened onto the

cup before placing it on the

motor base and operating

the Magic Bullet®.

Never store the cross blade

in the motor base without a

cup attached. The exposed

blades can present a very

dangerous hazard.

• To prevent leakage and/or

property damage, always

make sure your cross blade is

undamaged and the gasket

is completely seated in the

cross blade before each use.

Leakage may cause residue

buildup and damage the

motor base. Contact customer

service for assistance if any

component is damaged or

WARNING!

6

loose, or if you have

any questions.

• Once you have ﬁnished using

your Magic Bullet®, wait to

remove the cup/cross blade

assembly from the motor

base until the motor comes

to a complete stop and the

unit powers down completely.

Taking the cup o the unit

prior to complete power down

can cause damage to the

cross blade coupling and/or

motor gear.

Never run the Magic Bullet®

without food or liquid

ingredients in any of the cups.

• Your Magic Bullet® is not

intended to be an ice crusher.

Attempting to crush ice may

cause permanent damage

to the cross blades or cause

the unit to malfunction,

resulting in personal injury or

property damage.

CUP SAFETY

• To avoid leakage, do not

overﬁll the cup! Make sure

your ingredients and liquid do

not exceed the MAX line. The

Cyclonic Action® of your Magic

Bullet® requires room to

operate eectively. Exceeding

the MAX line can result in

7

leakage and may create a

dangerous pressurization

which can cause the vessel

and blade assembly to

separate.

• Periodically inspect your

Magic Bullet® components

for damage or wear that

may impair proper

function. Discontinue use and

replace components if you

detect cracking, crazing or

cloudiness, or other damage

to the plastic cups, tabs (on the

side of the cup), or the motor

base. You may purchase new

cups and cross blades by

contacting customer service.

We recommend replacing

your cross blade and cups

every 6 months or as needed

for optimal performance.

ELECTRICAL SAFETY

• Do not use this product

in locations with dierent

electrical speciﬁcations, or

plug types or with any type

of plug adapter or voltage

converter device. Doing so

may result in ﬁre, electric

shock, personal injury or

product damage. Use of

adapters and converters or

use in locations with dierent

WARNING!

8

electrical speciﬁcations or

plug types is considered an

unauthorized modiﬁcation of

the and will therefore void

the warranty.

• CAUTION: In order to avoid

a hazard due to inadvertent

resetting of the thermal

cut-out, this appliance must

not be supplied through an

external switching device,

such as a timer, or connected

to a circuit that is regularly

switched on and o by

the utility.

• The use of attachments,

including canning jars, is

not recommended and may

cause ﬁre, electric shock,

personal injury, or product

damage and will void the

warranty.

• To avoid risk of electric shock,

never immerse the cord,

plug, or motor base in water

or other liquids which can

conduct an electrical current.

• Always disconnect the

appliance from the power

supply if it is left unattended

and before assembling,

disassembling or cleaning.

• Switch o the appliance and

disconnect from power supply

9

before changing accessories

or handling moving parts.

• Periodically inspect the

cord,

plug, and machine

for damage. Do not operate

the Magic Bullet® if its cord

or plug is damaged. Cease

operation of the Magic Bullet®

if it has been dropped or

damaged, or if it malfunctions

in any manner (including

making a louder-than-normal

or abnormal sound when

blending).

• If the supply cord is damaged,

it must be replaced by the

manufacturer, its service

agent or similarly qualiﬁed

persons in order to avoid

a hazard.

• Do not use the Magic Bullet®

outdoors or in inclement

weather.

• Do not allow the cord to hang

over the edge of the table

or counter.

• Do not pull, twist, or damage

the power cord.

• Do not allow cord to touch hot

surfaces, including

the stove.

10

VENTILATION SAFETY

• The motor base features

ventilated openings on the

bottom to ensure reliable

motor operation and

prevent over-heating. To

prevent a ﬁre hazard, make

sure that these openings

remain unobstructed by dust,

lint, or other materials.

Never place your Magic

Bullet® on top of ﬂammable

items such as newspapers,

tablecloths, napkins, dish

towels, place mats or other

similar materials.

• CAUTION! Always operate

the Magic Bullet® on a level

surface, leaving unobstructed

space beneath and around

the motor base to permit

proper air circulation.

IMPORTANT MICROWAVE

SAFEGUARDS

• Do not place any of the Magic

Bullet® parts in a microwave,

oven or stove-top pot or

immerse in boiling water as

this may result in damage.

11

MEDICAL SAFETY

• The information contained in

this user guide is not meant

to replace the advice of your

physician. Always consult your

physician regarding health

and nutrition concerns.

MEDICATION

INTERACTIONS:

• If you are taking any

medication, especially

cholesterol medication, blood

thinners, blood pressure

drugs, tranquilizers, or

antidepressants, please check

with your physician before

trying any of the recipes.

• Avoid blending the following

seeds and pits, as they contain

a chemical known to release

cyanide into the body

when ingested: apple seeds,

cherry pits, plum pits, peach

pits, and apricot pits.

CLEANING & MAINTENANCE

INSTRUCTIONS

• Please follow the below

cleaning instructions before the

ﬁrst use, and after each use.

• Cleaning the Magic Bullet® is

easy. Simply place any of the

parts (except for the motor

base and cross blade) on the

12

top rack of the dishwasher or

hand wash with warm, soapy

water and rinse.

HERE’S HOW TO CLEAN

THE MAGIC BULLET®

• STEP 1: ALWAYS POWER

OFF and UNPLUG the motor

base from the outlet when

it is left unattended, before

assembling, disassembling,

changing accessories or

approaching parts that move

in use or when cleaning. Do

not attempt to handle the

appliance until all parts have

stopped moving!

• STEP 2: Make sure the

blending cup/cross blade

is not attached to the

motor base.

• STEP 3: Clean the individual

components (motor base,

cross blades, Magic Bullet®

blending cups).

MOTOR BASE:

• To avoid risk of injury, NEVER

use your hands or utensils to

clean the white actuator tabs

while the Magic Bullet® is

plugged in.

• NEVER submerge the

motor base in water or put

in the dishwasher.

13

• Do not remove the rubber

or plastic liners inside the

motor base.

• Use a sponge or dish cloth

dampened with warm soapy

water to wipe down the inside

and outside of the motor base

until clean.

• Pay particular attention to the

actuator tabs on the inside

of the motor base to loosen

any stuck or sticky debris from

drips and spills. If necessary

you may use a small brush to

scrub the area to ensure it is

kept clean.

CROSS BLADES:

Do not remove the gasket as this

may permanently damage the

cross blade and cause leakage.

• Dry the cross blades

completely. It is helpful to turn

the blade on its side in your

dish drainer to ensure BOTH

SIDES of the cross blade are

completely dried.

• We recommend replacing

your Magic Bullet® cross blade

every 6 months or as needed

for optimal performance.

14

BLENDING CUPS CUPS,

LIDS AND LIP RINGS:

• These items are all TOP

RACK dishwasher safe. We

recommend rinsing them and

giving them a quick brush with

a dish brush to remove any

dried debris before washing

them in the dishwasher.

NEVER use the sanitize cycle

to wash the blending cups as

this may warp the plastic.

• Regularly check the tabs (3)

on the sides of the cups for

damage (cracking, crazing,

breakage or rounding).

If the tabs are damaged,

discontinue use and replace

immediately to prevent

possible personal injury.

Save These

Instructions!

15

EN/ Explanation of the markings

EN/ This marking indicates that this product should

not be disposed with other household wastes

throughout the EU. To prevent possible harm to the

environment or human health from uncontrolled

waste disposal; recycle it responsibly to promote

the sustainable reuse of material resources. To

return your used device, please use the return and

collection systems or contact the retailer where the

product was purchased. They can take this product

for environmental safe recycling.

EN/ This product complies with the European

regulation no. 1935/2004 on materials and articles

intended to come into contact with food.

16

What’s Included.

stainless steel

cross blade

motor base tall cup

OLD SHORT CUP Tall cup

new short cup

17

Using the Magic Bullet®

Load the ingredients

into the cup (do not

exceed the MAX line.

Twist on the cross

blade until the

blade and cup are

tightly sealed.

1 2

Using the Magic Bullet® is as easy as 1, 2, 3:

3

Line up the tabs on the

cup with the tabs on the

motor base. Press the

cup down onto the base

to turn on the machine.

18

Here’s how it works:

The Magic Bullet® will blend for as long

as you press the cup down onto the

motor base. To stop blending, simply

release pressure on the cup.

“Lock-on” mode:

For hands-free operation, press down

and gently turn the cup clockwise until

the tabs lock under the lip of the motor

base. Once you are in lock-on mode,

the motor will run continually (do not

run for longer than a minute!). To stop

blending, simply twist the cup counter-

clockwise to release pressure on

the tabs.

19

CAUTION:

Before using the cross blade, check the

gasket to make sure it is not damaged

and it is completely seated in the cross

blade unit before each use.

Never put your hands or utensils near the

moving cross blades and never use your

hands or utensils to press the activator

buttons down while the motor base is

plugged in.

IF THE CROSS BLADE STOPS

SPINNING WHILE IN LOCK ON MODE,

IMMEDIATELY UNPLUG THE MAGIC

BULLET® Hard ingredients like carrots

or celery can get stuck in the cross blade

and stop it from turning. If this happens,

UNPLUG THE MAGIC BULLET® RIGHT

AWAY Remove the blade/cup assembly

from the motor base, and give ingredients

a good shake to unblock the cross blade.

If the cross blade still remains obstructed,

twist the cross blade attachment o of the

cup and carefully spin the metal blades

using a utensil (not your ﬁngers) to release

the blockage. Reattach the cross blade to

the cup, plug in the Magic Bullet® and try

again. It should spin normally.

NEVER RUN THE MAGIC BULLET

FOR MORE THAN ONE MINUTE AT A

TIME, AS IT CAN CAUSE PERMANENT

DAMAGE TO THE MOTOR If the motor

stops working, unplug the motor base

and let it cool for a few hours before

attempting to use it again. Your Magic

Bullet® has an internal thermal breaker

that shuts the unit o when it overheats.

Letting the thermal breaker cool down

should allow it to reset.

La pagina sta caricando ...

NutriBullet Magic Bullet Guida utente

NutriBullet Magic Bullet Guida utente

in altre lingue

Documenti correlati

Altri documenti