1 2 3 4 5
6
End of programme as soon as 龕远 / ꀌ邔錹ꃐ
(Finished/fluffing) indicator light flashes
Adding or removing laundry
The drying cycle can be interrupted in order to add or remove laundry.
The programme must then be continued or ended.
The drum and the door may be hot!
1. Open the door. The drying process is interrupted.
2. Load or remove laundry and close the door.
3. If required, select a new programme and additional functions.
4. Press the 駬
麡 / 鼥ꃐ (start/stop) button.
Emptying condensation
Empty the container after every use.
1. Remove the condensation container and hold it
level.
2. Open the locking cap.
3. Pour out the condensation.
Check the valve in the condensation container for dirt:
If there are fluff deposits on the valve
a rinse the valve under running water.
Also pour some tap water into the empty condensation container then pour it out again
through the valve.
To do this, press the valve in and allow all the water to drain out.
4. Close the locking cap.
5. Always push the tank fully back in until it locks in place.
If the ꃡ
館ꣅ / 镔鷀蕀m/l(Container/Cleaning) indicator
light comes on after emptying the container
a see page 10.
Cleaning the fluff filter
Clean the fluff filter after every use.
1. Open the door and pull out the fluff filter.
2. Remove the fluff (brush your hand over the fluff filter).
If the fluff filter is very dirty or blocked, wash it out with warm water
and dry thoroughly.
3. Replace the fluff filter.
4. Remove fluff from door/door area.
Switching off the dryer
Set the programme selector to 龕远 (Off).
Do not leave laundry in the dryer.
Removing the laundry
Your dryer has an automatic anti-crease function. The drum is moved at set intervals for 30 minutes after
the programme has ended. Laundry remains loose and fluffy (for 90 minutes, if additional ꀌ
邔錹ꃐ (Easy-
iron) function is selected - depending on model).
... and adapt to individual requirements
Never operate the dryer if it is damaged.
Inform your after-sales service.
Inspecting
the dryer
Sorting and loading laundry
Remove all objects from pockets.
Pay particular attention to cigarette lighters.
The drum must be empty before filling.
Your new dryer
Congratulations - You have chosen to buy a modern, high-quality
Siemens domestic appliance.
A distinctive feature of your dryer is its low energy consumption.
Every dryer which leaves our factory is carefully checked to ensure
that it functions correctly and is in perfect condition.
Should you have any questions, our after-sales service will be pleased
to help.
Disposal in an environmentally-responsible manner
Dispose of packaging in an environmentally-responsible manner.
This appliance is designated according to European directive
2002/96/EC which governs waste electrical and electronic
equipment (WEEE).
The directive provides an EU-wide framework for the return and
recycling of old appliances.
For further information about our products, accessories, spare parts
and services, please visit: www.siemens-home.com
Intended use
Contents Page
ʋ Preparation . . . . . . . . . . . . . . . . . . . . . . 2
ʋ Setting the programmes . . . . . . . . . . . . . 2
ʋ Drying . . . . . . . . . . . . . . . . . . . . . . . . 3/4
ʋ Notes on laundry . . . . . . . . . . . . . . . . . . 5
ʋ Care and cleaning . . . . . . . . . . . . . . . . . . 6
ʋ Overview of programmes . . . . . . . . . . . . 7
ʋ Installation . . . . . . . . . . . . . . . . . . . . . . . 8
ʋ Frost protection / Transport. . . . . . . . . . . 8
ʋ Technical data . . . . . . . . . . . . . . . . . . . . 9
ʋ Optional accessories . . . . . . . . . . . . . . . . 9
ʋ What to do if... / After-sales service . . . . 10
ʋ Safety instructions . . . . . . . . . . . . . . . .11
Preparing for installation, see page 8
Selecting and adjusting the programme
Drying
Condensation container
Control panel
Care and cleaning
Dryer cabinet, control panel, air cooler, moisture sensors
– Wipe off with a soft, damp cloth.
– Do not use abrasive cleaners or solvents.
– Remove detergent and cleaning agent residue immediately.
Clean the air cooler 5 to 6 times a year
or if
ꃡ館ꣅ / 镔鷀蕀m/l(Container/Cleaning) flashes after cleaning the fluff filter.
Air cooler
In order to clean it, the air cooler must be removed.
– Allow the dryer to cool.
– Residual water may leak out, so place an absorbent towel underneath
the maintenance door.
1. Unlock the maintenance door (1).
2. Fully open the maintenance door (2).
3. Turn both locking levers outwards (1).
4. Pull out the front insert (2).
5. Remove the air cooler.
Take care not to damage the air cooler.
When cleaning, use warm water only. Do not use hard or sharp-edged objects.
6. Clean the air cooler thoroughly and allow the water to drain off.
Clean the seals.
7. First insert the air cooler (handle at the bottom) and then the front insert.
8. Turn back both locking levers.
9. Lock the maintenance door.
Moisture sensors
The dryer is fitted with stainless steel moisture sensors. The sensors measure the level of
moisture in the laundry. After a long period of operation, a fine layer of limescale may form
on the sensors.
1. Open the door.
2. Clean the moisture sensors using a slightly damp sponge with a rough
surface.
Do not use steel wool or abrasive materials.
Select the drying programme ...
Press the 駬麡 / 鼥ꃐ
(start/stop) button
Only if your hands are dry.
Only hold the plug by the plug
casing.
Connecting the
mains plug
Drying
Information on laundry ...
Labelling of fabrics
Follow the manufacturer's care information.
( Drying at normal temperature.
'cLow-temperature drying a in addition, select 鼐
鴸莄龀邌 (Low heat).
)cDo not machine dry.
Be sure to follow the safety instructions a see page 11!
For example, do not use the dryer for the following fabrics:
– Airtight fabrics (e.g. rubber-coated fabrics).
– Delicate materials (silk, curtains made from synthetic material) a they may crease.
– Laundry contaminated with oil.
Before drying for the first time
– Do not put any laundry in the dryer. Set the programme selector to a timed programme
(a see page 7) and select 駬
麡 / 鼥ꃐ (start/stop). When the programme has finished, set
the programme selector to 龕
远 (Off).
Drying tips
– To ensure a consistent result, sort the laundry by fabric type and drying programme.
– Always dry very small fabrics (e.g. baby socks) together with large items of laundry
(e.g. hand towels).
– Fasten zips, hooks and eyelets, button covers and tie together cloth belts, strips, etc.
– Do not overdry easy-care laundry a risk of creasing.
Allow laundry to finish drying in the air.
– Do not iron laundry immediately after drying, fold items up and leave for a while a the
remaining moisture will then be distributed evenly.
– Knitted fabrics (e.g. T shirts, knitwear) often shrink when tumble dried for the first time
a do not use the 鵔
鼔莄龀+ (Extra Dry) programme.
– Starched laundry is not always suitable for dryers a starch leaves behind a coating that
adversely affects the drying operation.
– Use the correct dosage of fabric softener as per the manufacturer's instructions when
washing the laundry to be dried subsequently.
– Using a timed programme with a small laundry load a optimisation of the drying result.
Environmental protection/energy-saving tips
– Before drying, spin the laundry thoroughly in the washing machine a the higher the spin
speed, the shorter the drying time will be (consumes less energy), also spin easy-care
laundry.
– Use the maximum recommended fill level but do not overload laundry
a overview of programmes, see page 7.
– Make sure the room is well ventilated during drying.
– Clean the fluff filter after every drying cycle a see page 4.
– Do not block or seal the air inlet.
Only when the appliance is
switched off.
Drum
Programme selector
Only operate the dryer
with the fluff filter inserted.
Air inlet
Fluff filter
ʋ exclusively for domestic use,
ʋ only for drying fabrics which have been washed using
water.
Do not leave children unsupervised near the dryer.
Keep pets away from the dryer.
For a detailed programme overview, a see page 7.
Before using the dryer for the first time
run the drying cycle without any laundry a see page 7.
Additional functions/status
and service indicators
ˎ 鼐鴸莄龀
(Low heat)
Reduced temperature for delicate fabrics ', e.g. polyacrylic,
polyamide, elastane or acetate; for longer drying times.
ˎ ꀌ邔錹ꃐ
(Easy-iron)
Reduces creasing and prolongs the anti-creasing phase
after the programme has finished.
ꃡ館ꣅ / 镔鷀蕀 m/l
(Container/Cleaning)
Lit a empty the container for condensation.
Flashes
a clean the fluff filter and/or air cooler.