Programme end
Clean the filter and drain the
water container after each
drying cycle. (See chapter CARE
AND CLEANING.)
If the drying cycle is completed, the symbol
flashes on the display. If the Buzzer
(Signal) option is on, the acoustic signal
sounds intermittently for 1 minute.
If you do not turn off the
appliance, the crease guard
phase starts. Laundry can be
removed during this phase.
To remove the laundry:
1. Push the On/Off (Ein/Aus) button for 2
seconds to turn off the appliance.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
HINTS AND TIPS
Ecological hints
• Spin good the laundry before drying.
• Use the load volumes which are
specified in the programme chart.
• Clean the filter after each drying cycle.
• Do not use fabric softener to wash and
then dry. In the tumble dryer laundry
becomes soft automatically.
• Use the condensate as distilled water,
e.g. for steam ironing. If it is necessary
clean the condensate before (e.g. with a
coffee filter) to remove possible small
pieces of fluff.
• Always keep the airflow slots on the
bottom of the appliance clear.
• Make sure that is good airflow in the
appliance installation position.
Adjustment of the remaining
laundry moisture degree
To change the default degree of the
remaining moisture of the laundry:
1.
Turn on the appliance.
2.
Wait approximately 8 seconds.
3. Select 1 of available programmes.
4. Push at the same time and hold down
the Anti-crease (Knitterschutz) and
Time Dry (Zeitwahl) buttons.
One of the symbols goes into the view on
the display:
- the maximum dry laundry
- the more dry laundry
- the standard dry laundry
5. Push the Start/Pause button again
and again until you set necessary
degree.
6. To memorise the setting, push at the
same time the Anti-crease
(Knitterschutz) and Time Dry
(Zeitwahl) buttons for approximately 2
seconds.
Deactivating the Water
container (Behälter) indicator
1.
Turn on the appliance.
2.
Wait approximately 8 seconds.
3.
Select 1 of available programmes.
4.
Push at the same time and hold down
the Anti-crease (Knitterschutz) and
Delay Start (Zeitvorwahl) buttons.
One of 2 configurations is possible:
• the Water container (Behälter)
indicator: is on and the symbol
goes into the view - the
water container indicator is
permanently on
• the Water container (Behälter)
indicator: is off and the symbol
goes into the view - the
water container indicator is
permanently off
15