11
- Clean the inside of the jug under running
water. If necessary, use a soft brush.
- Thoroughly dry the jug with a clean, dry
cloth.
Description (g. A)
Your 212040 Princess soup maker has been
designed for making soups. The appliance is
suitable for indoor use only. The appliance is
suitable for domeic use only.
Fig. A1
1. Control panel
2. Motor unit
3. Overow sensor
4. Blade
5. Jug connector
6. Jug
7a. Minimum level indicator
7b. Maximum level indicator
8. Handgrip
9. Motor unit connector
10. Heating plate
Fig. A2
11. Start/op button
12. Program selection button
13a. Heating/blending indicator ("HEAT+STIR")
13b. Heating indicator ("HEAT")
13c. Blending indicator ("STIR")
Use
Setting the program (g. A)
• Press the program selection button (12)
1x to heat and blend the ingredients. The
heating/blending indicator (13a) comes on.
The process takes approximately 25
minutes. (Note: The appliance r heats
the ingredients, but does not directly art
blending the ingredients.)
• Press the program selection button (12)
2x to heat the ingredients. The heating
indicator (13b) comes on. The process
takes approximately 35 minutes.
• Press the program selection button (12)
3x to blend the ingredients. The blending
indicator (13c) comes on. The process
takes approximately 60 seconds.
Hints for use (g. A)
Warning!
Before assembly or disassembly, switch o
the appliance, remove the mains plug from
the wall socket and wait until the appliance
has cooled down.
- Always make sure that the ingredients are
between the minimum level indicator ("MIN")
and the maximum level indicator ("MAX").
- Do not switch on the appliance when the
jug is empty.
- Do not overload the appliance. If the motor
ops, immediately switch o the appliance,
remove the mains plug from the wall socket
and allow the appliance to cool down.
• Prepare the ingredients. Make sure that
the ingredients t in the jug.
• Place the jug (6) on a able and at surface.
• Put the ingredients into the jug (6).
• Mount the motor unit (2) onto the jug (6).
• Insert the mains plug into the wall socket.
• Set the program. Refer to the section
"Setting the program". The corresponding
program indicator (13) comes on.
• Press the art/op button (11) to art the
process.
• To interrupt the process within 10 seconds,
press the art/op button (11) again.
Note: After 10 seconds, the process cannot be
interrupted. In case of an emergency, remove
the mains plug from the wall socket.
• If the process is completed, the appliance
will beep. The corresponding program
indicator (13) arts ashing.
• Press the art/op button (11) to op the
process.
• Remove the mains plug from the wall socket.
• Allow the appliance to cool down completely.