Sony WS-FVX1 Manuale utente

Tipo
Manuale utente
© 2006 Sony Corporation Printed in Malaysia
Owner’s Record
The model and serial numbers are located
at the bottom of the unit. Record the serial
number in the space provided below. Refer
to them whenever you call upon your Sony
dealer regarding this product.
Model No. WS-FVX1
Serial No.______________
Precautions
On safety
Recommended for use with the Sony small
speaker system.
Be sure to place the speaker stand in a fl at,
horizontal place.
On placement
Use caution when placing the stand on a
specially treated (waxed, oiled, polished, etc.)
oor, as staining or discoloration may result.
On cleaning
Clean the pipe stand, the base, and the bracket
with a soft cloth slightly moistened with a
mild detergent solution. Do not use any type
of abrasive pad, scouring powder or solvent
such as thinner, benzene or alcohol.
If you have any questions or problems
concerning your system, please consult your
nearest Sony dealer.
Assembly
Adjust the height of the pipe stand,
and then attach the speaker to
the stand. When no adjustment is
necessary, go to 3.
1 Remove the speaker cord from the cable
holder of the pipe stand.
2 Loosen the two screws attached to the
pipe stand, and adjust the pipe stand to
a height of 835 mm to 1,050 mm. After
adjusting, tighten the screws. After
adjusting the height of the pipe stand,
insert the speaker cord in the cable holder
again.
3 Tightly secure the speaker to the mount
with the screw.
Specifi cations
Dimension (w/h/d) Approx. 280
×
835 - 1,050
×
280 mm
(
11
1
/8
× 32
7
/8
-
41
3
/8 × 11
1
/8
in.
)
(Diameter of
base: 280 mm
(
11
1
/8 in.
))
Mass Approx. 4 kg
(8 lb 14 oz)
Supplied accessories
Screw (2)
Design and specifi cations are subject to
change without notice.
English Français
Précautions
Sécurité
Utilisation recommandée avec le système de
petits haut-parleurs Sony.
Veillez à placer le support d’enceinte sur
une surface plane et horizontale.
Installation
Soyez particulièrement prudent lorsque vous
placez le support sur une surface ayant subi un
traitement spécial (cirée, huilée, polie, etc.),
car il peut laisser des taches ou entraîner la
décoloration du revêtement de sol.
Entretien
Nettoyez le tube socle, la base et l’applique
avec un chiffon doux légèrement imprégné
d’une solution détergente douce. N’utilisez
aucun type de tampon abrasif, de poudre à
récurer ou de solvant comme du dissolvant, du
benzène ou de l’alcool.
Pour toute question ou tout problème
concernant votre chaîne, n’hésitez pas à
consulter votre revendeur Sony le plus proche.
Montage
Réglez la hauteur du tube socle,
puis fi xez l’enceinte sur le socle. Si
aucun réglage n’est nécessaire, allez
à l’étape 3.
1 Retirez le cordon de l’enceinte du
protège-câbles du tube socle.
2 Desserrez les deux vis fixées au tube
socle, puis réglez la hauteur du tube socle
entre 835 mm et 1 050 mm. Une fois le
réglage terminé, resserrez les vis. Une fois
la hauteur du tube socle réglée, replacez
le cordon de l’enceinte dans le protège-
câbles.
3 Fixez solidement l’enceinte au support à
l’aide de la vis.
Caractéristiques
Dimensions (l/h/p) Environ 280
×
835 - 1 050
×
280 mm
(
11
1
/8
× 32
7
/8
-
41
3
/8 × 11
1
/8
po.
)
(Diamètre de la
base : 280 mm
(
11
1
/8 po.
))
Poids Environ 4 kg
(8 li 14 on)
Accessoires fournis
Vis (2)
La conception et les spécifi cations sont
sujettes à modifi cation sans préavis.
Deutsch
Sicherheitsmaßnahmen
Sicherheit
Empfohlen zur Verwendung mit einem
Kompaktlautsprechersystem von Sony.
Bitte stellen Sie den Lautsprecherständer auf
eine ebene, waagrechte Fläche.
Aufstellung
Seien Sie vorsichtig, wenn Sie den Ständer
auf einen besonders behandelten Fußboden
(gewachst, geölt, poliert usw.) stellen, da es zu
Flecken oder Verfärbungen kommen kann.
Reinigung
Reinigen Sie den Rohrständer, den Fuß
und den Montagebügel mit einem weichen
Tuch, das Sie leicht mit einer milden
Reinigungslösung angefeuchtet haben.
Verwenden Sie keine Scheuermittel,
Scheuerschwämme oder Lösungsmittel wie
Verdünnung, Benzin oder Alkohol.
Sollten am System Probleme auftreten oder
sollten Sie Fragen haben, wenden Sie sich
bitte an Ihren Sony-Händler.
Montage
Stellen Sie die Höhe des
Rohrständers ein und befestigen Sie
den Lautsprecher am Ständer. Wenn
keine Einstellung erforderlich ist,
weiter mit Schritt 3.
1 Entfernen Sie das Lautsprecherkabel vom
Kabelhalter des Rohrständers.
2 Lösen Sie die beiden Schrauben
am Rohrständer und stellen Sie den
Rohrständer auf eine Höhe von 835 mm
bis 1.050 mm ein. Nach dem Einstellen
die Schrauben anziehen. Führen Sie nach
Einstellen der Höhe des Rohrständers
das Lautsprecherkabel erneut in die
Kabelhalterung ein.
3 Fixieren Sie den Lautsprecher mit der
Schraube am Ständer.
Technische Daten
Abmessungen (B/H/T) ca. 280
×
835
- 1.050
×
280
mm
(Durchmesser
der Platte: 280
mm)
Gewicht ca. 4 kg
Standardzubehör
Schraube (2)
Änderungen, die dem technischen Fortschritt
dienen, bleiben vorbehalten.
Precauciones
Seguridad
Recomendado para su uso con el sistema de
altavoces pequeños Sony.
Asegúrese de colocar el soporte del altavoz
en un lugar plano y horizontal.
Ubicación
Tenga cuidado si coloca el soporte en suelos
con un tratamiento especial (encerados,
barnizados con aceites, pulidos, etc.), ya
que es posible que aparezcan manchas o se
descoloren.
Limpieza
Limpie el tubo de soporte, la base y el
soporte con un paño suave ligeramente
humedecido con una solución detergente
poco concentrada. No utilice ningún
estropajo abrasivo, detergente concentrado
ni disolventes como diluyentes, bencina o
alcohol.
Si tiene dudas o problemas sobre el sistema
de altavoces, póngase en contacto con el
proveedor Sony más cercano.
Montaje
Ajuste la altura del tubo de soporte
y, a continuación, je el altavoz al
soporte. Si no es necesario realizar
ningún ajuste, vaya al paso 3.
1 Extraiga el cable del altavoz del fijador de
cables del tubo de soporte.
2 Afloje los dos tornillos fijados al tubo de
soporte y ajústelo a una altura de 835 mm
a 1.050 mm. Una vez ajustado, fije los
tornillos. Tras ajustar la altura del tubo de
soporte, inserte el cable del altavoz en el
fijador de cables de nuevo.
3 Fije correctamente el altavoz al soporte de
montaje con ayuda del tornillo.
Especifi caciones
Dimensiones (an/al/prf) Aprox. 280
×
835 - 1.050
×
280 mm
(diámetro de la
base: 280 mm)
Peso Aprox. 4 kg
Accesorios suministrados
Tornillo (2)
El diseño y las especifi caciones están sujetos a
cambios sin previo aviso.
Español
Precauzioni
Sicurezza
Da utilizzare con il sistema diffusori Sony di
dimensioni ridotte.
Si raccomanda di posizionare il supporto
per diffusori su una superfi cie piana e
orizzontale.
Installazione
Prestare attenzione nel collocare il supporto
su un pavimento trattato con prodotti speciali
(quali cera, olio o lucidanti), onde evitare
macchie o scolorimento.
Pulizia
Pulire l’asta, la base e la staffa con un panno
morbido leggermente inumidito con una
soluzione detergente neutra. Non utilizzare
alcun tipo di spugnetta o polvere abrasiva, né
solventi quali diluente, benzina o alcol.
Per qualsiasi domanda o problema riguardante
il sistema, rivolgersi al rivenditore Sony più
vicino.
Assemblaggio
Regolare l’altezza dell’asta e
collegarvi il diffusore. Se non è
necessario effettuare la regolazione,
passare al punto 3.
1 Rimuovere il cavo dei diffusori dal
farmacavo dell’asta.
2 Allentare le due viti collegate all’asta
e regolarla ad un’altezza da 835 mm a
1.050 mm. Dopo la regolazione, serrare
nuovamente le viti. Dopo aver regolato
l’altezza dell’asta, reinserire il cavo dei
diffusori nel farmacavo.
3 Fissare saldamente il diffusore al supporto
mediante la vite.
Caratteristiche
tecniche
Dimensioni (l/a/p) Circa 280
×
835
- 1.050
×
280
mm
(diametro della
base: 280 mm)
Peso Circa 4 kg
Accessori in dotazione
Viti (2)
Il design e le caratteristiche tecniche sono
soggetti a modifi che senza preavviso.
Italiano
1
835 mm - 1050 mm
32
7
/
8
in. - 41
3
/
8
in.
2 3
Speaker Stand
WS-FVX1
2-684-224-11(1)
  • Page 1 1
  • Page 2 2

Sony WS-FVX1 Manuale utente

Tipo
Manuale utente