Peerless KLR62232 Guida d'installazione

Tipo
Guida d'installazione

Questo manuale è adatto anche per

12019-06-14 #:150-9227-1
ENG
KLR62232, KLR64255
22019-06-14 #:150-9227-1
Symbols
ENG
WARNING
ENG
#
Skip to step.
ENG
Do not overtighten screws.
ENG
ENG - This product is designed to be installed on wood stud, solid concrete or cinder block walls. Hardware is
included for wood stud, solid concrete and cinder block installation. Do not begin to install product until you have
read and understood the instructions and warnings contained in this user guide. Before installing make sure
the supporting surface will support the combined load of the equipment and hardware. Screws must be tightly
secured. Do not overtighten screws or damage can occur and product may fail. Never exceed the Maximum
Load Capacity. Always use an assistant or mechanical lifting equipment to safely lift and position equipment. This
product is intended for indoor use only. Use of this product outdoors could lead to product failure or personal
injury. Be careful not to pinch ngers when operating the mount. To reduce the risk of electric shock or re, do not
expose product to water or moisture. Be sure power cord is routed so that it will not be tripped on, stepped on,
or pinched by heavy items. Avoid overloading electrical outlets or extension cords. Always disconnect the power
cord from the power outlet when installing, servicing, or not using the product for an extended period of time. Do
not block ventilation slots or fan exhaust on product. Blocking airow could damage product. Arrange product to
allow air to ow freely around product. Keep product away from direct sunlight or any source of heat. For support
please call 800-4-SIGNAGE.
WARNING
32019-06-14 #:150-9227-1
Tools Needed for Assembly.
ENG
1
2
ENG To properly tighten screws: Tighten until screw
head makes contact, then tighten another 1/2
turn. Do not overtighten screws.
4
+1/2
3
5/32"
(4mm)
5/16"
(8mm)
3/8"
(10mm)
42019-06-14 #:150-9227-1
A (1)
enclosure B (1)
wall mount
G (1)
hook-on
bracket
F (1)
locking bracket
Parts List KLR62232
Part #
KLR64255
Part #Description Qty
Aenclosure 1 152-1544 152-1545
Bwall mount 1 ST635 ST640
C#14 x 2-1/2" wood screw 4 5S1-015-C03 5S1-015-C03
D8mm concete anchor 4 590-0320 590-0320
Epower strip 1 600-0370 600-0370
Flocking bracket 1 152-T1502 152-T1511
Ghook on bracket 1 152-T1508 152-T1520
HM5 x 20mm 3 510-1065 510-1065
Parts (Before beginning, make sure you have all parts shown below).
ENG
E (1)
power strip
52019-06-14 #:150-9227-1
D (4)
8mm concrete anchor
C (4)
#14 x 2-1/2" wood screw
H (3)
M5 x 20mm
1
B
Follow and complete instructions for included wall
mount.
ENG
62019-06-14 #:150-9227-1
2
B
A
Hold enclosure over display in desired location,
and make sure that it is level. Mark the top
location of the enclosure.
ENG
3
Remove display.
ENG
Loosen.
ENG
4mm
72019-06-14 #:150-9227-1
4
4a
4a
4b
ENG - When installing Peerless wall mounts on a wood stud wall covered with gypsum board (drywall), verify that
the wood studs are a minimum of 2" x 4" nominal size. Do not install over gypsum board thicker than 5/8".
WARNING
Wood stud wall.
ENG Concrete/Cinder block.
ENG
4a-1 Use stud nder to locate and
mark stud center lines.
ENG
82019-06-14 #:150-9227-1
4a-2
⅛"
G
B
G
B
Mark mounting holes on stud center lines.
Mounting holes should be positioned 1/8" under
the horizontal cover line.
ENG
cover line
ENG
cover line
ENG
92019-06-14 #:150-9227-1
5
4a-4
3/8"
(10mm)
4a-3
5/32"
(4mm)
C (2)
G
B
Mounting hole must center on stud.
ENG
2.5"
(64mm)
5/32"
(4mm)
Drill mounting holes into supporting surface
(2.5" (64mm) minimum depth required).
ENG
Level wallplate. Install using wood screws provided.ENG
Maximum 80 in. • lb (9 N.M.).
ENG
10 2019-06-14 #:150-9227-1
4b-1
4b
G
4b-2
5/16"
(8mm)
ENG - When installing Peerless wall mounts on a concrete wall, the wall must be at least 8" thick with a minimum
compressive strength of 2000 psi. When installing Peerless wall mounts on a cinder block wall, the cinder blocks
must meet ASTM C-90 specications and have a minimum nominal width of 8". Do not drill into mortar joints!
Be sure to mount in a solid part of the block, generally 1" (25 mm) minimum from the side of the block. It is
suggested that a standard electric drill on slow setting is used to drill the hole instead of a hammer drill to avoid
breaking out the back of the hole when entering a void or cavity. Never attach concrete expansion anchors to
concrete or cinder block covered with plaster, drywall or other nishing material.
WARNING
Mark mounting holes on stud center lines.
Mounting holes should be positioned 1/8" under
the horizontal cover line.
ENG
cover line
ENG
2.5"
(64mm)
5/16"
(8mm)
Do not drill into mortar joints.
ENG
Drill mounting holes into supporting surface
(2.5" (64mm) minimum depth required).
ENG
cover line
ENG
B
⅛"
G
B
cover line
ENG
11 2019-06-14 #:150-9227-1
4b-4
3/8"
(10mm)
1b-34b-3
D (2)
C (2) G
Insert anchor ush to concrete.
ENG
D
Level wallplate. Install using wood screws provided.ENG
Maximum 80 in. • lb (9 N.M.).
ENG
12 2019-06-14 #:150-9227-1
5
A
B
GG
6
Hang enclosure onto hook on bracket.ENG
Mark the bottom location of the enclosure.
ENG
GA
Enclosure must fully seat
onto bracket.
ENG
13 2019-06-14 #:150-9227-1
F
B
7
7a
7a
7b
ENG - When installing Peerless wall mounts on a wood stud wall covered with gypsum board (drywall), verify that
the wood studs are a minimum of 2" x 4" nominal size. Do not install over gypsum board thicker than 5/8".
WARNING
Wood stud wall.
ENG Concrete/Cinder block.
ENG
7a-1
1/16"
B
F
cover line
ENG
cover line
ENG
23.98
(61cm)
14 2019-06-14 #:150-9227-1
F
B
C (2)
8
7a-3
3/8"
(10mm)
7a-2
5/32"
(4mm)
Mounting hole must center on stud.
ENG
2.5"
(64mm)
5/32"
(4mm)
Drill mounting holes into supporting surface
(2.5" (64mm) minimum depth required).
ENG
Level wallplate. Install using wood screws provided.ENG
Maximum 80 in. • lb (9 N.M.).
ENG
15 2019-06-14 #:150-9227-1
This page intentionally left blank.ENG
16 2019-06-14 #:150-9227-1
B
F
7b-1
7b
7b-2
5/16"
(8mm)
ENG - When installing Peerless wall mounts on a concrete wall, the wall must be at least 8" thick with a minimum
compressive strength of 2000 psi. When installing Peerless wall mounts on a cinder block wall, the cinder blocks
must meet ASTM C-90 specications and have a minimum nominal width of 8". Do not drill into mortar joints!
Be sure to mount in a solid part of the block, generally 1" (25 mm) minimum from the side of the block. It is
suggested that a standard electric drill on slow setting is used to drill the hole instead of a hammer drill to avoid
breaking out the back of the hole when entering a void or cavity. Never attach concrete expansion anchors to
concrete or cinder block covered with plaster, drywall or other nishing material.
WARNING
Mark mounting holes.
ENG
cover line
ENG
2.5"
(64mm)
5/16"
(8mm)
Do not drill into mortar joints.
ENG
Drill mounting holes into supporting surface
(2.5" (64mm) minimum depth required).
ENG
1/16"
B
F
cover line
ENG
17 2019-06-14 #:150-9227-1
C (2)
7b-4
3/8"
(10mm)
1b-37b-3
D (2)
Insert anchor ush to concrete.
ENG
D
Level wallplate. Install using wood screws provided.ENG
Maximum 80 in. • lb (9 N.M.).
ENG
F
18 2019-06-14 #:150-9227-1
8
10
9
Tighten.
Apretar.
Serrer.
Anziehen.
Aandraaien.
Stringere.
Utáhněte.
Utiahnite.
Apertar.
Sıkmak.
ENG
ESP
FRN
DEU
NEL
ITL
ČEŠ
SLK
POR
TÜR
4mm
19 2019-06-14 #:150-9227-1
11
A
12
Do not overtighten screws.
ENG
4mm
H (3)
G
Peerless-AV Europe
Unit 3 Watford Interchange,
Colonial Way, Watford, Herts,
WD24 4WP, United Kingdom
Customer Care
44 (0) 1923 200 100
www.peerless-av.com
© 2019, Peerless Industries, Inc.
Peerless-AV de Mexico
Ave de las Industrias 413
Parque Industrial Escobedo
Escobedo N.L Mexico 66062
Servicio al Cliente
01-800-849-65-77
www.peerless-av.com
© 2019, Peerless Industries, Inc.
Peerless-AV
2300 White Oak Circle
Aurora, IL 60502
Ph: (800) 865-2112
Fax: (800) 359-6500
www.peerless-av.com
© 2019, Peerless Industries, Inc.
Peerless Industries, Inc. (“Peerless-AV”) warrants to original end-users that each Peerless-AV® mounting product will be free from defects
in material and workmanship, under normal use, for the applicable warranty period (from date of the original installation of the product).
At its option, Peerless-AV will repair or replace, or refund the purchase price of, any product which fails to conform with this warranty.
Any implied warranty of merchantability or tness for a particular purpose shall be limited to the period of the
express warranty set forth below.
In no event shall Peerless-AV be liable for incidental or consequential damages, whether or not secured by a
security device which may be included with the product.
Some states do not allow limitations on how long an implied warranty lasts, or the exclusion of incidental or consequential damages, so
the above limitation and/or the above exclusion may not apply to you.
This warranty does not cover damage caused by incorrect selection, installation or the failure to follow Peerless-AV instructions or
warnings when installing, using or storing the product.
This warranty gives specic legal rights, and you may also have other rights which vary from state to state. To make a warranty claim in
North America, contact Peerless-AV customer care at 1-800-865-2112. See complete global warranty information for regions outside North
America at www.peerless-av.com/en-uk/customer-care/warranties-returns.
LIMITED FIVE-YEAR WARRANTY
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16
  • Page 17 17
  • Page 18 18
  • Page 19 19
  • Page 20 20

Peerless KLR62232 Guida d'installazione

Tipo
Guida d'installazione
Questo manuale è adatto anche per

in altre lingue