Marine Electrical Prod

ucts

-Series Selector Battery Switch

PN 9001e

Blue Sea Systems Inc. Phone (360) 738-8230

425 Sequoia Drive Fax (360) 734-4195

Bellingham, WA 98226 USA E-mail [email protected]

www.bluesea.com

• 3/8”-16 (M10) provide maximum conductivity and corrosion resistance

• One-piece to reduce risk of overheating

• 7/8” (22.22mm) length to accept multiple cable terminals

Case design:

• Allows surface mounting or rear panel mounting

• Accepts up to 4/0 AWG (95mm²) battery cables

Specifi cations

Inrush Rating: 2.5 sec. 1750 Amperes DC

Cranking Rating: 100 sec. 900 Amperes DC

Ignition Protected

marked

Agency Specifi cations

• Meets all American Boat and Yacht Council (ABYC) requirements for

battery switches

• UL Listed - UL 1107 for electric power switches

• Meets UL 1500 and SAE J1171 external ignition protection requirements

Guarantee

Any Blue Sea Systems product with which a customer is not satisfi ed may be

returned for a refund or replacement at any time.

• Desconecte el terminal positivo de la batería antes de la instalación.

• Prima di eseguire l’installazione, disconnettere il terminale positivo della batteria.

• Consult marine electrical professional for proper wiring application.

• Consultez un professionnel de l’électricité marine pour installer le câblage correctement.

• Consulte a un electricista marino profesional para la aplicación de alambrado apropiada.

• Per assicurarsi che i cavi siano correttamente collegati, rivolgersi ad un elettricista specializzato in motori marini.

Installation

• Mount in an easily accessible location close to the batteries.

• Montez-le dans un endroit facilement accessible près des batteries.

• Monte en una ubicación fácilmente accesible cerca de la batería.

• Battery cable terminals must be attached under nut and lock washer. Torque 140 in-lb (15.82 N·m).

• Les cosses des câbles de batterie doivent être fi xées sous la rondelle de sûreté et l’écrou – couple de serrage de 15,82 N·m (140 lb-po).

• Los terminales de los cables de batería deberán ser sujetados debajo de la tuerca y la arandela. Apriételos a una torsión de 15,82 N·m (140 lbs-pul).

• I terminali del cavo della batteria vanno attaccati con un dado e una rondella elastica: coppia di 15,82 N·m (140 lbs-in).

Operation

• Turn all appliances off before turning the battery switch to OFF.

• Éteignez tous les appareils électriques avant de mettre l’interrupteur de batterie sur ARRÊT.

• Apague todos los artefactos antes de girar el interruptor de batería a APAGADO (OFF).

• Spegnere tutte le apparecchiature prima di muovere l’interruttore della batteria su OFF (spento).

• Do not switch to OFF while engine is running.