4
- Enter the complete Internet address or press the speed
dialling number or dial the number to which you have asso-
ciated the Internet address.
To confirm your setting. The display shows:
SEND: YES
To start the transmission.
Transmission starts as described above.
T
O
RECEIVE
MESSAGES
(
SMS
)
The fax machine can receive up to 30 messages (SMS). When a
message (SMS) is received, the "
" led starts blinking, the fax
machine, if previously programmed, sends out an acoustic signal and
the message "SMS RECEPTION" and then the
icon appear on
display.
As in message transmission, you can set some parameters to:
- ensure the correct operation of SMS service if you have
more than a telephone set connected to the same tel-
ephone line, see later on "For an appropriate message (SMS)
reception if you own more than one telephone set and
only one telephone line".
- configure the fax machine to notify the reception of a mes-
sage through an acoustic signal, see later on "To configure
the fax machine for notifying the reception of a message
(SMS) through an acoustic signal".
important
To make sure that SMS messages will be received,
check that the fax machine is set to connect to the telephone
line after at least 2 rings. See the "To change the number
of rings" section of the "More sophisticated operations"
chapter of the fax machine user’s manual.
T
O
READ
A
MESSAGE
(
SMS
)
RECEIVED
When the icon appears on display, it means that you
have received one or more messages (SMS). At this point,
if you want to read them, you must:
The display shows:
SEND SMS
/ Until the following message appears on display:
SMS RECEIVED XX
"XX" is the number that appears in the upper right-hand
side corner and it indicates the total number of messages
received (max. 30). It is useful if you want to know how
many messages you have received and, therefore, how
many you can still receive.
To confirm your setting. The display shows:
DISPLAY LIST
If "MEM ALMOST FULL", "DELETE REC. SMS", appear
on display, it means that the memory for messages received
already contains 28 messages, therefore, it is almost full. It is
advisable to delete some messages from this memory. See
"To delete/edit/send again a message (SMS)".
If, on the other hand, "MEMORY FULL", "DELETE REC.
SMS", appear on display, it means that the memory for
messages received is full. In this case, you must delete at
least one message from this memory. See "To delete/edit/
send again a message (SMS)".
To confirm your setting. The display shows from left to right:
the reference number which identifies the messages present
on the list of messages received (from the oldest message to
the most recent one), the
icon for messages still unread,
the correspondent's telephone number, the text of the mes-
sage or part of it, and the date and time.
/ Press
|
or
}
, once to show all the message-related data
and the text of the message on the fax machine. To stop the
text on display, press
|
or
}
again.
At this point you can press
to select the displayed
message or press
/
to find on the above-mentioned list
another message that you wish to select, and then press
.
In both cases the fax machine shows:
DELETE
Press to return the fax machine to the initial stand-by
mode or to continue the procedure as follows:
/ To select one of the other available options: "ANSWER",
"SEND", "EDIT" and "PRINT".
ANSWER: to answer a message received (see procedure
below).
EDIT and SEND: to edit and send a message again (see
later on "To delete/edit/send again a message (SMS)".
PRINT: to print the data concerning the message you have
just selected and the text of the message. See "To print
every single message within a list", section "The lists".
To confirm your choice.
To return the fax machine to the initial stand-by mode.