![](//vs1.manuzoid.it/store/data-gzf/eae447e4b5840b0ac433f7584a1a19a6/2/000347459.htmlex.zip/bgf.jpg)
13
Add Petrol
WARNING: Always use a safety petrol
container. Do not smoke when adding
petrol to the fuel tank. Do not add petrol
when you are inside an enclosure. Before
you add petrol, stop the engine and let the
engine cool for several minutes.
(Figure 9) Fill the
fuel tank (A)
to the
FULL (B)
position
with regular unleaded petrol. Do not use premium unleaded
petrol. Make sure the petrol is fresh and clean. Leaded petrol
will increase deposits and shorten the life of the valves.
How To Start The Engine
WARNING: The electrical system has an
operator presence system that includes a
sensor switch for the seat. These
components tell the electrical system if the
operator is sitting on the seat. This system
will stop the engine when the operator
leaves the seat. For your protection, always
make sure this system operates correctly.
NOTE:
The engine will not start unless you depress the
clutch/brake pedal and move the blade rotation control to the
DISENGAGE position.
Push the clutch/brake brake pedal complete ly forward. 1.
Keep your foot on the pedal.
Make sure the blade rotation control is in the 2.
DISENGAGE position.
Move the throttle control completely forward to the 3.
CHOKE or FAST position. Some mo dels have a
separate choke knob. Pull the choke knob to the full
CHOKE position.
Turn the ignition key to the START position. 4.
NOTE:
If the engine does not start after four or five
tries, move the throttle control to the FAST position.
Again try to start the engine. If the engine will not start,
see the
Troubleshooting
section.
Slowly move the throttle control to the SLOW position. 5.
To start a hot engine, move the throttle con trol to a 6.
position between FAST and SLOW.
Mowing and Bagging Tips
For a lawn to look better, check the cutting level of the 1.
mower housing See authorized dealer.
For the mower housing to cut level, make sure the tires 2.
have the correct amount of air pressure.
Every time you use the unit, check the blade. If the 3.
blade is bent or damaged, immediately replace the
blade. Also, make sure the nut for the blade is tight.
Keep the blade(s) sharpened. Worn blades will cause 4.
the ends of the grass to turn brown.
Do not cut or bag grass that is wet. Wet grass will not 5.
discharge correctly. Let the grass dry before cutting.
Use the left side of the mower housing to trim near an 6.
object.
Discharge the cut grass onto the mowed area. The 7.
result is a more even discharge of cut grass.
When you mow large areas, start by turning to the right 8.
so that the cut grass will dis charge away from shrubs,
fences, driveways, etc. After one or two rounds, mow in
the op posite direction making left turns until fin ished.
If the grass is very high, cut two times to de crease the 9.
load on the engine. First cut with the mower housing in
the highest position and then lower the mower housing
for the second cut.
For better engine performance and an even discharge 10.
of the cut grass, always operate the engine with the
throttle in FAST position.
When you use a bagger, operate the engine with the 11.
throttle in FAST position and the speed control pedal
pushed 1/3 to 1/2 for ward.
After each use, clean the bottom and top of the mower 12.
housing for better performance. Also, a clean mower
housing will help pre vent a fire.