12
7.
CONTROLS AND
INDICATORS
B
E
C
D
A-Programme Selector - Rotatng the knob
n both drectons t's possble to select the
desred dryng program. To cancel the
selectons or swtch off the dryer rotate the
knob on OFF.
B- Dsplay Dgt - The dsplay shows the
remanng tme for dryng, the postponed
tme n case of delayed start selecton and
other notfcatons settng.
C-Buttons -
1.Start/Pause Button
To start the selected program and/or
suspend t.
2.Super Easy Iron - Ths opton allows to
reduce folds and tangles, thanks to
alternatng movements of the drum durng
and after dryng and automatcally, settng
the ron dryng level (the dryng level settng
can be modfed after the opton selecton)
The opton can be set up to fve mnutes after
the start of the cycle and s actvated only on
automatc cycles.
3.Rapds Button - It's possble swtch an
automatc program to RAPID program, up to
3 mnutes after the start of the cycle. The
progressve pressure ncreases the tme (30-
45-59 mnutes). After ths selecton to reset
the automatc dyng functonng s necessary
to s w tch off t h e dryer I n c a se of
ncompatblty, all LEDs flash quckly for 3
tmes.
12
2
3
4
5
6
8
7
A
1
30'
30'
45'
45'
59'
59'
Time Remaining
Time Remaining
4.Dryng Selecton Button
It allows to set the desred dryness level
edtable opton up to 5 mnutes after the
startng of the cycle:
- Ready to Iron : It leaves the
garments slghtly wet to facltate
ronng.
- Dry Hanger : To get garment ready
to be hang
- Dry wardrobe : For laundry that
can be drectly stored
-Extra-dry : To get completely dry
garments, deal for full load.
Ths applances s equpped wth Dryng
Manager Functon. On automatc
cycles, each level of ntermedate
dryng, pror to the reachng the selected
one, s ndcated by flashng the lght
ndcator correspondng to the degree of
d r y n g r e a c h e d I n c a s e o f
ncompatblty, all LEDs flash quckly for
3 tmes.
5.Delay Start Button - It allows to
delay the start of the program from 1 to
24 hours n 1-hour ntervals. The delay
selected s shown on the dsplay. After
pressng the START button the tme
showed decrease hour after hour.
Openng of the porthole wth delayed
start set, after re-closng the porthole,
press start agan to resume the
countng.
6. Memo - Ths opton allows you to
store the optons set on a cycle.
STORAGE > When the cycle s runnng
push the button "memory" for three
seconds. The control lght "memory"
flashes for three tmes and stores the
set optons connected to the cycle
selected n the flange. .
Recall: After the selecton of the cucle
Push the button "memory" for recall the
stored optons (not the cycle)
7.Tme cycle selecton - It's possble
transform a cycle from automatc to
programmed, up to 3 mnutes after the
start of the cycle. The progressve
pressure ncreases the tme n 10-
mnute ntervals.
After ths selecton to reset the
automatc dyn g f u n c t o n n g s
necessary to swtch off the dryer In case
of ncompatblty, all LEDs flash quckly
for 3 tmes.