Candy CCV 150 SKEU Manuale utente

Please read this instruction booklet carefully before using your Candy Wine Cooler

Wine Cooler

Frigorifero da sottobanco

Refrigerateur a vin

Table of Contents

Maintenance Your Wine Cooler ------------------------------------------------

Technical Specifications ---------------------------------------------------------

Troubleshooting --------------------------------------------------------------------

Moving Your Wine Cooler--------------------------------------------------------

Vacation Time-----------------------------------------------------------------------

Care and Maintenance------------------------------------------------------------

Change The Light Bulb-----------------------------------------------------------

Cleaning Your Wine Cooler------------------------------------------------------

How To Use The Thermostat -------------------------------------------------

Operating Your Wine Cooler-----------------------------------------------------

Reversing the Door Swing of Your Wine Cooler---------------------------

Installation of Your Wine Cooler------------------------------------------------

Before Using Your Wine Cooler------------------------------------------------

Installation Instructions-----------------------------------------------------------

Important Safety Instructions----------------------------------------------------

Parts and Features-----------------------------------------------------------------

1

3

5

5 5

6

7

6

7

8

2

4

ENGLISHENGLISH

REVERSIBLE DOOR

8. LAMP SWITCH

7. LEVELLING LEGS

6. WINE RACK

5. CHROME SHELVES

4. CABINET

3. INTERIOR LAMP

2. THERMOSTAT KNOB

1. GLASS DOOR

PARTS AND FEATURES

2

3

Important Safety Instructions

Read all instructions before using the appliance.

Never allow children to operate, play with, or crawl inside the appliance.

Never clean appliance parts with flammable fluids. The fumes can create

a fire hazard or explosion.

Do not store or use gasoline or any other flammable vapours and liquids

in the vicinity of this or any other appliance. The fumes can create a

fire or explosion.

easily climb inside.

take off the door, leave the shelves in place, so that children may not

Before you throw away your old wine cooler:

INSTALLATION INSTRUCTIONS

Before Using Your Wine Cooler

Clean the interior surface with lukewarm water using a soft cloth.

Before connecting the appliance to the power source, let it stand

upright for approximately 2 hours. This will reduce the possibility

of a malfunction in the cooling system from handling during

transportation.

2 wine rack

1 user manual

6 slide out shelves

Check to be sure the following parts are included:

Remove the exterior and interior packing, including protective foam on

door panels .

Installation of Your Wine Cooler

Place your appliance on a floor that is strong enough to support the

appliance when it is fully loaded. To level your appliance, adjust the

legs at the front of the appliance.

Plug the appliance into an exclusive properly installed-grounded wall

outlet. Do not under any circumstances cut or remove the third

(ground) prong from the power cord. Any questions concerning

power and or grounding should be directed toward a certified

electrician or an authorized products service center.

Avoid locating the appliance in moist areas. Too much moisture in

the air will cause frost to form quickly on the evaporator.

Locate the appliance away from direct sunlight and sources of heat

(stove, heater, radiator, etc.). Direct sunlight may affect the acrylic

coating and heat sources may increase electrical consumption.

Extreme cold ambient temperatures may also cause the appliance

not to perform properly.

Allow 5 inches of space between the back and sides of the appliance,

which allows the proper air circulation to cool the compressor.

Warning: Improper use of the grounded plug can result in the risk of

electrical shock. If the power cord is damaged, have it replaced by an

authorized products service center.

Before reversing the door ,the power must be shut off.

All parts removed must be saved to do the reinstallation of the door.

NOTE:

This wine cooler has the capability of either opening the door from the left

or right side. The unit is delivered to you with the door opening from the

left side. Should you desire to reverse the opening direction, please

follow these instructions.

Reversing the Door Swing of Your Wine Cooler

4

This wine cellar has been built with the door hinges on the right. If you wish

to change the opening direction, follow the instructions below:

2. Remove the screws (1) that hold the upper hinge (5) (right side) to the

frame. Take away the upper hinge (5).

3. Lift the door and place it on a padded surface to prevent scratching it.

4. Remove the screws(8) that hold the lower hinge(2) and Make sure to

Remove the lower hinge(2).

5. Remove the hole cover plate(7) to the right side.

6.

Install the lower hinge (2) onto the left side of the lower frame with screws (8).

7. Set the door to its place making sure the door seat at the lower hinge(2).

8.While holding the door in the closed position secure the upper hinge (5) in the

top frame of left side with screws (1). Please remember that do not tighten

the two screws(1) until the top of the door is levelled with the counter top.

1. Remove the upper hinge cover(6) first

9. Install the upper hinge cover(6) on the upper hinge..

Door opening from left side

Door opening from right side

Do not store food in wine cooler, as interior temperature may not get cool

enough to prevent spoilage. As a natural result of condensation, in summer

months or area of high humidity, the glass door may build up moisture on

the outside .Just wipe it away.

IMPORTANT SAFEGUARDS

It is recommended you install the wine cooler in a place where the ambient

temperature is between 22 -25 degree Celsius .If the ambient temperature

in above of below the recommended temperature ,conditions may cause

interior temperature to fluctuate.

OPERATING YOUR WINE COOLER

HOW TO USE THE THERMOSTAT

5

If the interior light is left on, the temperature inside the wine cooler will be higher.

The above temperatures may fluctuate depending on whether or not the interior

bulb is on or off of whether the bottles are located on the lower/middle or lower

section.

Recommended Temperatures for chilling Wine

Red wines: 15.5-18.5 C

Dry/White Wines 10-15 C

Sparkling Wines 7.2-9.5 C

Rose Wines 9.5-10.5 C

By turning the thermostat knob, you can

adjust the temperature of the

compartment you desired. Turn it

clockwise, the temperature of the

compartment will become cooler

and cooler.

Before removing the light bulb, either unplug the refrigerator or disconnect

the electricity leading into the refrigerator at the main power supply. Failure

to do so could result in electrical shock or personal injury.

There is a 4 to 6 C variance between the top and bottom shelves of the

wine chiller. Therefore, If you have set the wine chiller for red wine only

and you want to place a mix of white and red wines, you should place the

white wine bottles on the bottom shelves and the red wines on the top

shelves.

CHANGING THE LIGHT BULB

CARE AND MAINTENANCE

All parts removed must be saved to do the replacement of the light bulb.

NOTE:

There is an additional wine rack at bottom section of the unit where you

can store up to 6 wine bottles. This rack is removable for cleaning purpose.

Shelf is chrome plated. To accommodate different size bottles, they

can be moved up or down by sliding them out the tracks first. Shelves are

designed to accommodate maximum amount of bottles.

Wine Rack

Shelves

6

Light bulb should not exceed 5 watts.

It may also be necessary to periodically wipe the bottom part of the storage

area,as the wine cooler is designed to retain humidity, and condensation

may collect there.

Most power failures are corrected within a few hours and should not

affect the temperature of your wine cooler if you minimize the number

of times the door is opened. If the power is going to be off for a longer

period of time, you need to take the proper steps to protect your contents.

Power Failure

Maintenance of Your Wine Cooler

The outside of the wine cooler should be cleaned with mild detergent and

warm water.

Wash the shelves and trays with a mild detergent solution.

Wash the inside with a warm water and baking soda solution. The solution

should be about 2 tablespoons of baking soda to a liter of water.

Unplug the wine cooler, and remove the bottles.

Cleaning Your Wine Cooler

Be sure the wine cooler stays in the upright position during transportation.

Tape the doors shut.

Turn the levelling screws up to the base to avoid damage.

Securely tape down all loose items inside your wine cooler.

Remove all the bottles.

Moving Your Wine Cooler

During long absences, remove all the bottles; unplug your wine cooler, clean

your wine cooler, and leave the door open slightly to avoid possible formation

of condensation, mold, or odors.

Vacation Time

7

You can solve many common wine cooler problems easily, saving you the

cost of a possible service call. Try the suggestions below to see if you can

solve the problem before calling the servicer.

Troubleshooting

8

The switch is in the "OFF" position.

The bulb has burned out.

The wine cooler is unplugged.

The home circuit breaker or fuse has tripped.

The wine cooler does not have the correct clearances.

The door gasket does not seal properly.

The temperature control is not set correctly.

The door is not closed completely.

The door is opened too often.

A large amount of contents has been added to the wine

cooler.

The room temperature is hotter than normal.

The wine cooler does not have the correct clearances.

The door gasket does not seal properly.

The door is not closed completely.

The door is opened too often.

External environment may require a higher setting.

Wine cooler is

not cold enough.

The circuit breaker tripped or blown fuse.

Wine cooler does

not operate.

PROBLEM

TROUBLESHOOTING GUIDE

POSSIBLE CAUSE

Not plugged in.

Check to be sure the temperature control setting.

Compressor turns

on and off frequently

The light does

not work.

The shelves are out of position.

The gasket is dirty.

The doors were reversed and not properly installed.

The wine cooler is not level.

Contraction and expansion of the inside walls may

cause popping and crackling noises.

As each cycle ends, you may hear gurgling sounds

caused by the flow of refrigerant in your wine cooler.

The rattling noise may come from the flow of the

refrigerant,which is normal.

Check to assure that the wine cooler is level.

Vibrations.

The wine cooler

seems to make

too much noise.

The door will not

close properly.

Technical specifications:

For detailed specifications, please refer to the nameplate at the back of the wine cellar. The

specifications are subject to change without prior notice due to products improvement.

ITALIANITALIAN

2

8. INTERRUTTORE DELLA LAMPADA

7. PIEDINI LIVELLANTI

6. CREMAGLIERA DEL VINO

5. RIPIANI IN ACCIAIO

4. STRUTTURA

3. LAMPADA INTERNA

2. MANOPOLA DEL TERMOSTATO

1. PORTA DI VETRO

7

8

9

1

FRENCHFRENCH

2

8. INTERRUPTEUR DE LAMPE

7. PIEDS DE NIVELLEMENT

6. PORTE-VIN

5. TABLETTES CHROMÉES

4. CABINET

3. LAMPE INTÉRIEURE

2. BOUTON THERMOSTAT

1. PORTE EN VERRE

2

La pagina si sta caricando...

Candy CCV 150 SKEU Manuale utente

Candy CCV 150 SKEU Manuale utente

Documenti correlati

Altri documenti