UNLEADED PETROL: if using unleaded
petrol, you must use a totally synthetic 2-
stroke engine oil or branded 2-stroke engine
oil (see table).
CAUTION: never start the engine with dry
pump as some mechanical parts could be
damaged.
PUMP PRIMING: before starting and if the
pump is empty, fill it with water through the
appropriate cap (A). Replace the cap and
tighten it.
STARTING:
1) Open fuel tap lever (B) by moving to
vertical position (open).
2) Set switch to “on” position “I”, (F).
3) Set the throttle lever (C) to half open
position.
4) Close the choke lever (D), downward
position (for cold engine only).
5) Pull the starter rope until the engine fires.
6) As soon as the engine fires once, set the
choke lever (D) to open position (upward).
WORKING: the water flow can be adjusted
by setting the throttle lever (C).
STOP: switch to stop position “O”.
DAILY MAINTENANCE:
1) All residual water must be evacuated
through the drainage cap (E) situated on
the lower part of the pump. This operation
must be done regularly as frozen water
would irreparably damage the pump.
2) Rinse the pump with clean fresh water
after use with dirty water (or salted water
and other liquids, Marinamac / Agrimac).
EVERY 20 HOURS: clean and ensure spark
plug gap is 0,5 0,6 mm.
EVERY 40 HOURS:
1) Replace spark plug (champion RDJ8J).
2) Clean air filter, more frequently when
working in dusty conditions.
STORAGE: empty fuel tank and run engine dry.
RECOMMENDATIONS:
1) Use an efficient suction filter.
2) Ensure suction tube (G) is securely
tightened.
3) P45 must never be used for salt water or
other corrosive liquids.
ENSURE ALL MAINTENANCE OR REPAIR
WORK IS CARRIED OUT BY AN
AUTHORISED SERVICE CENTER.
SAFETY:
1) Never re-fuel while the engine is running.
Do not smoke during this operation.
2) Only use the pump in a well ventilated
area.
3) Never use for pumping inflammable
liquids or acids.
4) Be careful of the hot surfaces on the unit.
EUROPEAN CONFORMITY INFORMATION
THIS PRODUCT MEETS THE FOLLOWING
EUROPEAN DIRECTIVE:
98/37/CEE MACHINERY (SAFETY)
DIRECTIVE
DIRECTIVE 2000/14/CEE (ANNEX V)
ENGINE OUTPUT (Kw) 1,7
MAX CAPACITY (lt/min) 150
MAX HEAD (m) 58
MAX SUCTION HEAD (m) 6
ENGINE SPEED
AT MAX POWER (min
-1
) 8500
GUARANTEED SOUND POWER LEVEL
LwAav (dBA) (ISO 3744) 110
MEASURED SOUND POWER LEVEL
LwAav (dBA) (ISO 3744) 108,5
3
UK
OPERATOR’S MANUAL