14
If the external flexible cable is damaged it must
be replaced by a qualified technician or by the
Tehcnical Center,in order to avoid accidents;
Children should be supervised to ensure that
they do not play with the appliance.
Final user shall not replace the batteries. Refer
to the Technical Service center.
If liquid from batteries goes in touch with clo-
thes or skin, wash with water and refer to a
doctor. A. Battery charger
DESCRIPTION
A. Socket for battery charging
B. Motor unit
C. Dust container
D. ON/OFF switch
E. Button to unblock the dust container F.
Filter unit
G. Crevice tool
H. Nozzle
I. Wall bracket
FIXATION OF THE WALL-MOUNTED BRA-
CKET
Measure the distance between the holes si-
tuated at the back of the bracket and drill
two holes in the wall at the same distance.
Put a plug in the holes and screw the
screws in the holes (by letting them more
or less 5 millimetres out of the wall).
Fix the bracket by putting the screws into
the widest part of the holes situated at the
back of the bracket and slide the bracket
downwards.
INSTRUCTIONS FOR USE
The vacuum cleaner is powered by batte-
ries.
Plug in the charger’s plug into the unit’s
phone jack that is on the bottom of the
handle for charging. When the unit is
being charged, the charging indicator is
on (which is shown by red light). Once ful-
ly charged just take out the unit for use
anywhere.
After use, recharge the unit as instructed
above. For safety purposes only use the
charger supplied by the manufacturer.
Before use, please charge the vacuum for
at least 16 hours.
Switch the unit on and off by pressing the
on/off switch.
Press the button of the front lid (E) to sepa-
rate the two parts, make sure that the filter
unit (F) is clean and in the right position.
Assemble on the appliance the crevice
tool, or the nozzle as needed.
Once finished turn off the unit, leaving the
switch on ON/OFF.
Empty the container of what you have pi-
cked up after each use.
To do this, press the (E) button, separate
the two parts and remove the filter unit
Empty the container and clean the filter
unit.
MAINTENANCE
Detach the dust container from the motor
unit by pressing down the release button
(E).
Empty the dust container.
To clean the filter you can use your ordi-
nary vacuum cleaner or you can shake it
or if necessary, wash the filter in lukewarm
soapy water. In the last case rinse it af-
terwards with clear water and make sure
that the filter is completely dry before re-
inserting it in position.
Don’t forget to put the filter in position af-
ter removing it for cleaning.
Damaged or very dirty filter should be re-
placed. Therefore ask to the nearest after
sale service.