Barco F50 WUXGA Guida d'installazione

F50 WUXGA
Barco
Marca
Barco
Modello
F50 WUXGA
Categoria
Supporti per proiettori
Tipo
Guida d'installazione

Questo manuale è adatto anche per

1
2
4
3
Getting started
This installation guide describes how to install the air inlet filter and exhaust air kits. For more information, including technical specifications
or product specifications, visit the product website at www.barco.com or read your projector user manual.
Installation Guidelines
• The exhaust kit must only be used with ceiling mounted projectors.
• The air filter kit is sold separately.
• The exhaust air kit and air inlet filter can be installed separately of one another.
• If the exhaust is to be directed into a false ceiling, this area must be well-ventilated. However, attention must be paid to ensure that the
ventilation does not override the projector’s i
nternal fans.
• Minimum safety distance (clearance) between the bottom of the projector and the ceiling is at least 15cm / 6” (see Installation Step 1).
• Maximum ambient temperature for projector with air inlet filter installed is 35°C / 95°F.
• Do not try to force parts into position; if there is resistance, remove the part, reposition and try again.
• Do not overtighten screws.
• Do not block the air inlet or the exhaust air outlet.
• Hot air is exhausted from the rear air outlet. Do not place any heat-sensitive objects in the vicinity of the exhaust vent.
Note! The exhaust air kit is only intended for use with ceiling mounted projectors
Installation
Note! The exhaust air kit and air filter kit is an accessory for F50- and CT- series projectors only.
Verify that the installation area meets the relevant
technical and environmental requirements, as
illustrated above.
Position the air inlet filter onto the projector grill,
making sure that the plastic guide on the filter
enters the grill properly. Install the filter with a
M3x8 screw at the right side (reference 1) and two
M3x14 screws at the left side (reference 2).
Loosen the two ceiling mount fastening screws
(reference 3 and 4). Remove the center rib.
Slide the duct into the ceiling mount tracks
as illustrated. Make sure that the side of the
duct clicks into position, as shown in the detail
illustration. Install the rib side screws (reference
5). Replace and fasten the two ceiling mount
screws (reference 3 and 4).
Position the ceiling mount cover on the projector
so that the tabs at the front of the ceiling cover
enter the slots on the rear of the projector (view
A). Install and fasten the two screws (reference 6).
Position the side cover on the projector as
illustrated. Install two M3x8 screws at the rear
end of the projector (reference 7) and two M3x20
screws at the front end of the projector (reference
8).
Thread the flexible hose (reference 9) for the
exhaust air onto the exhaust duct and fasten it
with the hose clamp (reference 10).
(Max length = 200cm).
1. Verify installation requirements. 2. Install air inlet filter (optional). 3. Install duct to ceiling cover. 4. Install ceiling mount cover to projector. 5. Install side cover to projector. 6. Mount flexible hose.
Note! Successful installation of the air inlet
filter will trigger automatic changes in the
projector software and LFM schedule.
Note! Max. ambient temperature with air
filter installed is 35°C.
min. 15cm
must be
≥90⁰
1
1
2
3
4
5
A
6
6
7
8
9
10
1
2
5
4
3
7
6
7
Kit contents
Item Description
1 Hose clamp
2 Flexible hose Ø125mm.
Max length = 200cm.
3 Ceiling cover
4 Ceiling cover rib
5 Exhaust duct
6 Side cover
Size Qty Description
PT3x7 2 Ceiling cover rib
M3x6 2 Ceiling cover
M3x8 2 Side cover
M3x20 2 Side cover
R9801322/R9801323
Fasteners
R9801320/R9801321
Item Description
7 Air inlet filter
Size Qty Description
M3x8 1 Air inlet filter
M3x14 2 Air inlet filter
Fasteners
601-0326-04
Installation Guide
F50- & CT- Series Exhaust Air Kit & Air Filter Kit
WEEE INFORMATION
This product conforms to all requirements of the EU Directive on waste
electrical and electronic equipment (WEEE). This product shall be recycled
properly. It can be disassembled to facilitate proper recycling of it’s individual
parts.
Consult your dealer or relevant public authority regarding drop-off points for
collection of WEEE.
WEEE-ANGABEN
Dieses Produkt erfüllt alle Auflagen aus der EU-Richtlinie für Elektro- und
Elektronik-Altgeräte (WEEE). Dieses Produkt kann sachgemäß recycelt werden.
Es kann zerlegt werden, um die Einzelteile ordnungsgemäß zu recyceln.
Fragen Sie Ihren Händler oder die zuständigen Behörden
nach
Entsorgungsstellen für Elektro- und Elektronik-Altgeräte.
INFORMATION WEEE
Cet appareil est conforme à la Directive EU relative au recyclage des
équipements électriques et électroniques (WEEE). Cet appareil doit être
recyclé correctement. Il peut être démonté pour faciliter le recyclage de
chaque pièce séparément.
Consultez votre revendeur ou les autorités publiques compétentes concernant
les points de collecte WEEE.
INFORMACIÓN WEEE
Este producto cumple todos los requisitos de la Directiva de la UE sobre
residuos de equipos eléctricos y
electrónicos. Este producto debe reciclarse
adecuadamente. Puede desmontarse para facilitar el adecuado reciclado de
cada una de sus piezas.
Consulte a su distribuidor o al organismo público pertinente acerca de los
puntos limpios para la recogida de residuos de equipos eléctricos y electrónicos.
INFORMAZIONI SU WEEE
Questo dispositivo è conforme a tutti i requisiti della direttiva UE (WEEE) sullo
smaltimento di apparecchiature elettriche ed elettroniche. Questo prodotto
deve essere riciclato correttamente e può essere smontato per agevolare il
riciclaggio dei singoli componenti.
Per informazioni sui p
unti di raccolta WEEE, consultare il rivenditore o l’autorità
preposta.
WEEE INFORMATION
Dette produktet tilfredsstiller alle krav i EU direktivet 2002/96/EC somgjelder
brukt elektrisk og elektronisk utstyr. Dette produktet skal resirkuleres forsvarlig.
Det kan demonteres slik at de enkelte deler kan resirkuleres forsvarlig.
Kontakt din forhandler eller relevant offentlig myndighet angående
returpunkter for innsamling av WEEE.
english
deutsch
francais
español
italiano
norsk
WEEE INFORMATION
This product conforms to all requirements
of the EU Directive on waste electrical
and electronic equipment (WEEE). This
product shall be recycled properly. It can be
disassembled to facilitate proper recycling of it’s
individual parts.
Consult your dealer or relevant public authority
regarding drop-off points for collection of WEEE.
For details, please visit the Barco website at:
http://www.barco.com/en/AboutBarco/weee.
WEEE-ANGABEN
Dieses Produkt erfüllt alle Auflagen aus der
EU-Richtlinie für Elektro- und Elektronik-
Altgeräte (WEEE). Dieses Produkt kann
sachgemäß recycelt werden. Es kann zerlegt
werden, um die Einzelteile ordnungsgemäß zu
recyceln.
Fragen Sie Ihren Händler oder die zuständigen
Behörden nach Entsorgungsstellen für
Elektro- und Elektronik-Altgeräte. Für weitere
Informationen, besuchen Sie bitte die Website
unter: http://www.barco.com/en/AboutBarco/
weee.
INFORMATION WEEE
Cet appareil est conforme à la Directive
EU relative au recyclage des équipements
électriques et électroniques (WEEE). Cet
appareil doit être recyclé correctement. Il peut
être démonté pour faciliter le recyclage de
chaque pièce séparément.
Consultez votre revendeur ou les autorités
publiques compétentes concernant les points
de collecte WEEE. Pour plus de détails, veuillez
visiter le site web Barco à: http://www.barco.
com/en/AboutBarco/weee.
INFORMACIÓN WEEE
Este producto cumple todos los requisitos
de la Directiva de la UE sobre residuos
de equipos eléctricos y electrónicos. Este
producto debe reciclarse adecuadamente.
Puede desmontarse para facilitar el adecuado
reciclado de cada una de sus piezas.
Consulte a su distribuidor o al organismo público
pertinente acerca de los puntos limpios para
la recogida de residuos de equipos eléctricos
y electrónicos. Para obtener más información,
visite la página web de Barco: http://www.
barco.com/en/AboutBarco/weee.
INFORMAZIONI SU WEEE
Questo dispositivo è conforme a tutti i
requisiti della direttiva UE (WEEE) sullo
smaltimento di apparecchiature elettriche
ed elettroniche. Questo prodotto deve
essere riciclato correttamente e può essere
smontato per agevolare il riciclaggio dei singoli
componenti.
Per informazioni sui punti di raccolta WEEE,
consultare il rivenditore o l’autorità preposta.
Per ulteriori informazioni, visitare il sito web
Barco: http://www.barco.com/en/AboutBarco/
weee.
WEEE INFORMASJON
Dette produktet tilfredsstiller alle krav
i EU direktivet 2002/96/EC som gjelder
brukt elektrisk og elektronisk utstyr. Dette
produktet skal resirkuleres forsvarlig. Det
kan demonteres slik at de enkelte deler kan
resirkuleres forsvarlig.
Kontakt din forhandler eller relevant offentlig
myndighet angående returpunkter for
innsamling av WEEE. For mer informasjon, se
Barco sin webside: http://www.barco.com/en/
AboutBarco/weee.
  • Page 1 1
  • Page 2 2

Barco F50 WUXGA Guida d'installazione

F50 WUXGA
Barco
Marca
Barco
Modello
F50 WUXGA
Categoria
Supporti per proiettori
Tipo
Guida d'installazione
Questo manuale è adatto anche per
Scarica il pdf
rapporto

in altre lingue

Documenti correlati