4. Security
Once the screen is safely suspended, please tighten the bolts on the bottom right and left corner of the
bracket using a screwdriver (DO NOT OVER TIGHTEN). This engages the front plates to the wall mounting
plate to ensure the screen cannot be lifted from the wall (fig. 7).
5. Adjusting the tilt mechanism
Now that the screen is safely suspended on the
wall, using an allen key loosen the fixing on the tilt
mechanism (fig. 8).
Once you have chosen your desired tilt angle
tighten the fixing on the tilt mechanism once again.
PT1
INSTRUCTION
MANUAL
CONSULT AUTHORISED SERVICE PERSONNEL FOR
THE INSTALLATION OF THIS UNIT. INSTRUCTIONS
MUST BE FOLLOWED PRECISELY FOR SAFE AND
STABLE INSTALLATION. RAW INTERNATIONAL ARE
NOT LIABLE FOR ANY DAMAGE OR INJURY CAUSED
BY MISHANDLING OR IMPROPER INSTALLATION.
INSTALLATION (PLEASE READ CAREFULLY)
INSTALLATION OF THIS UNIT SHOULD ONLY BE CARRIED OUT BY QUALIFIED
TECHNICIANS. INSTALL IN AN APPROPRIATE LOCATION ONLY AFTER CHECKING
WALL STRUCTURE AND DURABILITY FOR ACCIDENT PREVENTION. CONSULT A
QUALIFIED BUILDER IF IN ANY DOUBT AS TO STRUCTURAL INTEGRITY OF WALL.
bracket
screw driver
screw driver
Fig. 5 Fig. 6
screen
Fig. 7 Fig. 8
allen key
List of components Spacers
M4x20mm x 4 M5x20mm x 4 M6x20m x 4 M8x20mm x 4 17x8.3x5 x 4
M4X600mm x 4 M5x55mm x 4 M6x55 x 4 M8x55mm x 4 17x8.3x10 x 4
3mm hex key x 1 M5x75mm 4 5mm hex key x 1 M8x75mm x 4 17x8.3x20 x 4
4mm hex key x 1 6mm hex key x 1 17x8.3x30 x 4
17x8.3x40 x 4