Kodak smile Manuale utente

User Guide

KODAK SMILE

INSTANT DIGITAL PRINTER

Imprimante numérique instantanée

Stampante istantanea digitale

Sofortdigitaldrucker

Impresora digital instantánea

Guide de l'utilisateur

Guida utente

Benutzerhandbuch

Guía del usuario

2 | EN

EN | 3

English

Français

Italiana

Deutsche

Español

TABLE OF CONTENTS

TABLE DES MATIÈRES  INDICE  INHALTSVERZEICHNIS  TABLA DE CONTENIDO

58

77

4

22

41

4 | EN

INTRODUCTION

Thank you for purchasing the KODAK SMILE

Instant Digital Printer. This User Guide is

intended to provide you with guidelines to

ensure that operation of this product is safe

and does not pose risk to the user. Any use

that does not conform to the guidelines

described in this User Guide may void the

limited warranty.

Please read all directions before using the

product and retain this guide for reference.

This product is intended for household use

only. It is not intended for commercial use.

This product is covered by a limited one-year

warranty. Coverage is subject to limits and

exclusions. See warranty for details.

SPECIFICATIONS

• Dimensions: 4.625 L x 3.188 W x 0.938 H

(11.75 x 8.15 x 2.5 cm)

• Weight: 7.2 oz (204 g)

• Colors Available: Black/White, White/Yel-

low, Blue, Green, Red

• Battery Capacity: 700mAh

• Battery Type: Lithium-polymer

• Prints Per Charge: ~40

• Supported Photo Paper: KODAK ZINK 2 x

EN | 5

3 sticky-back photo paper

BOX CONTENTS

KODAK SMILE Instant Digital Printer

Starter Pack of KODAK ZINK Paper

User Guide

SAFETY PRECAUTIONS

• Do not attempt to disassemble this device

for any reason.

• Never leave your printer or the ZINK® paper

in an area that might become extremely

hot or where it will be exposed to direct

sunlight for a long time. This can cause

your printer to overheat or suer other

problems.

• Don’t get it wet! If you need to clean your

printer, use a soft cloth that’s been slightly

dampened with water or rubbing alcohol,

and gently wipe away any dirty spots. Don’t

submerge the whole thing in water, ever.

• Be careful with your printer. Try not to drop

it, or shake it violently. The inside of the

printer has a lot of very small parts that

could break if they are jostled around too

much.

• Do not use products such as alcohol,

gasoline, diluent, or any other organic

solvent when cleaning or attempting to

clean this product.

• Do not use this device in an environment

6 | EN

where it will be exposed to heavy dust or

humidity/moisture.

• Do not use this printer while bathing or in

a shower.

• Do not place or charge the printer where it

can fall or be pulled into a tub or sink.

• Do not place, drop, or submerge the

printer in water or any other liquid.

• If the printer somehow falls into water

despite you taking all of the above

precautions, please do not reach into

the water to retrieve it, especially if it

is charging. If it is charging, unplug it

immediately and then retrieve it.

• Take care that objects do not fall and

liquids are not spilled onto the printer.

• This printer absolutely will not work

without downloading the ANDROID

or iOS application. If you do not have

an ANDROID phone or an IPHONE,

unfortunately, this printer will not work for

you.

EN | 7

PRODUCT OVERVIEW

Micro USB

charging port

Paper slot

Charging

indicator LED

Reset button

8 | EN

Power indicator LEDs

IDLE SOLID WHITE

ERROR

SOLID RED

DATA TRANSFER

BLINKING BLUE

NO PAPER

BLINKING RED

PRINTING

BLINKING WHITE

EN | 9

GETTING READY FOR USE

Charge the SMILE

Before using the printer, connect it to the

charger by plugging the micro USB cable

into the designated micro USB charging port

on the side and allow it to fully charge.

If the red indicator LED light is lashing, this

means that the battery is low and you should

plug the printer in for it to recharge. While

the printer is charging, the indicator LED will

be a solid red light. Once the process has

completed, the indicator LED will change to

a solid green light.

Load the Paper

Load your ZINK paper into the printer: Follow

the steps below to quickly and easily get

your new printer loaded with ZINK sticky-

back paper so you can start printing photos!

1. Open the paper tray in the back by

removing the tray cover at the rear of the

device.

10 | EN

2. Load the blue calibration sheet in with

the barcode facing down. Place the other

plain sheets on top with the glossy side

facing you. Try to avoid touching the

glossy side so you don’t get ingerprints

on it.

3. When you print your irst photo after

loading the ZINK paper, the blue

calibration sheet will be slowly ejected

from the printing slot. Your photo will print

after the calibration sheet inishes.

Download the App

Download the KODAK

SMILE App from the

APPLE APP STORE or

GOOGLE PLAY. You will

need the app installed

on your phone for the

printer to work.

EN | 11

Power it On/O

1. To turn the printer on, slide the small ridged

panel away from the center. This will cause

the printing slot to pop up and the LED light

strip to illuminate.

2. To turn the printer o, simply press down

the pop-up printing slot.

PRINTING PICTURES WITH KODAK

SMILE

1. Turn the printer on by sliding the small

ridged panel away from the center.

2. Make sure BLUETOOTH on your phone is

enabled.

3. Open up the KODAK SMILE App from your

phone, follow the instructions to pair your

12 | EN

printer with the app, and start using your

new KODAK SMILE printer!

If you have trouble connecting your printer

from the application, try following these steps

instead:

1. Access your phone’s BLUETOOTH settings,

usually found under the general Settings

menu.

2. Make sure the printer is on irst, and then

allow your phone to scan for new devices.

3. You will see “KODAK SMILE XX:XX” appear

in the BLUETOOTH list. The X’s will be

replaced with speciic letters and numbers

which correspond to your speciic printer.

Tap on it to start pairing.

4. After a couple of seconds, your phone

should say “paired”.

In Case of Paper Jam

If the printer jams while attempting to print,

follow these steps to resolve the issue:

1. Use a small pin/needle/paper clip to press

the reset button on the side of the printer

next to the charging port.

EN | 13

2. When the reset process inishes, it should

clear the paper jam.

Your KODAK SMILE printer is also equipped

with a special release on the top panel to

retrieve paper in case of paper jams.

NOTE: Manually removing paper from the

printer head is not recommended and should

only be done once you’ve tried resetting the

printer in the way recommended above. Please

be advised that removing paper in this manner

can damage the printer head, and you should

be extraordinarily careful while doing this.

1. Hold the printer with the ridged panel

toward you. Make sure the top panel is

closed and the printer is o.

2. Press down gently, but irmly, with both

thumbs in the center of the panel (right

about where the KODAK logo is found).

14 | EN

3. Push the panel away from you. It should lift

o, exposing the paper in the printing area.

4. As gently as possible, try to remove the

jammed paper and replace the panel by

sliding it back into place until it clicks. DO

NOT YANK THE PAPER.

EN | 15

NOTE: Do not use this method to load the

paper into the printer. This is only to be done in

case of paper jams, and is not intended to be a

regular method of loading paper.

WARRANTY INFORMATION

LIMITED WARRANTY ON KODAK SMILE INSTANT

DIGITAL PRINTER

THIS LIMITED WARRANTY GIVES YOU SPECIFIC

LEGAL RIGHTS AND YOU MAY ALSO HAVE

OTHER RIGHTS, WHICH VARY FROM STATE TO

STATE.

WE WARRANT THAT DURING THE WARRANTY

PERIOD, THE PRODUCT WILL BE FREE FROM

DEFECTS IN MATERIALS AND WORKMANSHIP.

LIMITATION OF LIABILITY

TO THE EXTENT NOT PROHIBITED BY LAW,

16 | EN

THIS WARRANTY IS EXCLUSIVE AND IN LIEU

OF ALL OTHER WARRANTIES, ORAL, WRITTEN,

STATUTORY, EXPRESS OR IMPLIED. EXCEPT

FOR THE EXPRESS WARRANTIES CONTAINED

IN THIS LIMITED WARRANTY STATEMENT

AND TO THE EXTENT NOT PROHIBITED BY

LAW, WE DISCLAIM ALL OTHER WARRANTIES,

EXPRESSED OR IMPLIED, STATUTORY OR

OTHERWISE, INCLUDING WITHOUT LIMITATION,

THE WARRANTIES OF MERCHANTABILITY AND

FITNESS FOR A PARTICULAR PURPOSE. SOME

STATES DO NOT ALLOW DISCLAIMERS OF

IMPLIED WARRANTIES, SO THIS DISCLAIMER

MAY NOT APPLY TO YOU. TO THE EXTENT

SUCH WARRANTIES CANNOT BE DISCLAIMED

UNDER THE LAWS OF YOUR JURISDICTION,

WE LIMIT THE DURATION AND REMEDIES OF

SUCH WARRANTIES TO THE DURATION OF THIS

EXPRESS LIMITED WARRANTY.

OUR RESPONSIBILITY FOR DEFECTIVE GOODS

IS LIMITED TO REPAIR, REPLACEMENT OR

REFUND AS DESCRIBED BELOW IN THIS

WARRANTY STATEMENT.

WHO MAY USE THIS WARRANTY? C&A

Marketing, Inc. located at 114 Tived Lane East,

Edison, NJ (“we”) extend this limited warranty

only to the consumer who originally purchased

the product (“you”). It does not extend to any

subsequent owner or other transferee of the

product.

WHAT DOES THIS WARRANTY COVER? This

EN | 17

limited warranty covers defects in materials and

workmanship of the KODAK SMILE Instant Digital

Printer (the “product”) for the Warranty Period as

deined below.

WHAT DOES THIS WARRANTY NOT COVER?

This limited warranty does not cover any damage

due to: (a) transportation; (b) storage; (c) improper

use; (d) failure to follow the product instructions

or to perform any preventive maintenance; (e)

modiications; (f) unauthorized repair; (g) normal

wear and tear; or (h) external causes such as

accidents, abuse, or other actions or events

beyond our reasonable control.

WHAT IS THE PERIOD OF COVERAGE? This

limited warranty starts on the date of your

purchase and lasts for one year (the “Warranty

Period”). The Warranty Period is not extended if

we repair or replace the product. We may change

the availability of this limited warranty at our

discretion, but any changes will not be retroactive.

WHAT ARE YOUR REMEDIES UNDER THIS

WARRANTY? With respect to any defective

product during the Warranty Period, we will, at our

sole discretion, either: (a) repair or replace such

product (or the defective part) free of charge or

(b) refund the purchase price of such product if

an exchange unit cannot be provided.

HOW DO YOU OBTAIN WARRANTY SERVICE?

To obtain warranty service, you must contact us at

18 | EN

8445161539 or by email at kodak@camarketing.

com during the Warranty Period to obtain a

Defective Merchandise Authorization (“DMA”)

number. No warranty service will be provided

without a DMA number and return shipping

costs to our facilities shall be assumed by you, the

purchaser. Shipping costs of the replacement unit

to you shall be assumed by us.

CUSTOMER SERVICE CONTACT

INFORMATION

Should you experience any problems with your

product, please contact us before returning the

item to the place of purchase. WE’RE HERE TO

HELP!

U.S. Support:

kodak@camarketing.com

8445161539

International Support:

kodakintl@camarketing.com

8445161540

EN | 19

20 | EN

FEDERAL COMMUNICATION

COMMISSION INTERFERENCE

STATEMENT

This device complies with Part 15 of the FCC

Rules. Operation is subject to the following

two conditions: (1) This device may not cause

harmful interference, and (2) this device must

accept any interference received, including

interference that may cause undesired

operation.

This equipment has been tested and found

to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC

Rules. These limits are designed to provide

reasonable protection against harmful

interference in a residential installation.

This equipment generates, uses and can

radiate radio frequency energy and, if not

installed and used in accordance with the

instructions, may cause harmful interference

to radio communications. However, there is

no guarantee that interference will not occur

in a particular installation. If this equipment

does cause harmful interference to radio or

television reception, which can be determined

by turning the equipment o and on, the user

is encouraged to try to correct the interference

by one of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the

La pagina sta caricando ...

Kodak smile Manuale utente

Kodak smile Manuale utente

in altre lingue

Documenti correlati

Altri documenti