5019 318 33068
AKR 641 - AKR 643
Preliminary information for installing the hood:
Disconnect the power supply at the domestic main switch before carrying out electrical connections.
1. Fix 2 support brackets D (Fig. 1) to the sides of the wall unit (one each side) using 2 screws per bracket
(the brackets must be parallel with the lower edge of the unit).
Position the support bracket so that it is against the back of the wall unit, making sure that the rear edge
of the bracket matches the back of the hood.
Drill an opening at the top of the wall unit for the exhaust pipe and the power supply cable.
2. Fix 2 support brackets E (Fig. 2) to the sides of the hood (one each side).
a. Pull out the deflector;
b. remove the grease filter/s;
c. from the inside of the hood, secure the support brackets using two screws P per bracket, making
sure to place the brackets as high as possible (near the outlet duct), then tighten the screws.
3. Fit the hood inside the wall unit, being careful to position the hood bracket E above the wall unit bracket
D (Fig. 1-2).
Insert the power supply cable through the opening made for the purpose.
4. Secure the hood with two screws in front (Fig. 3 - one each side).
5. Carry out the electrical connection to the mains power supply, only turn on the power supply with
assembly completed.
6. If necessary, adjust the alignment by loosening the screws P of the brackets E mounted on the hood
(Fig. 2) until the hood and the lower edge of the wall unit line up perfectly, then tighten the screws again.
7. Adjust the deflector slideout stroke according to the depth of the wall unit by adjusting the two retainers
F (Fig. 5). In this way the front will be perfectly aligned with the wall unit.
a. Loosen the screws of the retainers F;
b. Adjust by moving the retainers backwards or forwards;
c. tighten the screws of the retainers.
8. Fix an outlet duct to the collar C supplied. The outlet duct diameter should be the same as that of the
collar (Fig. 4). The exhaust pipe must be long enough to vent externally (extractor version) or must reach
the top of the wall unit (filter version).
9. Fix the collar C (snap-close) to the top section of the hood discharge.
To facilitate installation, the collar has a mark G that must match the specific guide H on the exhaust
duct.
10. Complete the installation of the exhaust duct.
Refit the grease filter/s, connect the hood to the power supply and check for correct hood operation.
INSTALLATION - ASSEMBLY INSTRUCTIONS
PL SK H RUS
CZ
BG RO GB
31833068.fm Page 19 Monday, December 23, 2002 10:00 AM