Version 1.2
Inputs for User Manual
NTG7 MID, NTG7 PREMIUM
NTG7 HIGH, NTG7 PREMIUMPLUS
1.5 FCC/ISED statements (North America)
FCC IC: T8GNTG7PREPLUS & IC: 6434A-NTG7PREPLUS
Modification statement:
The party responsible for the compliance has not approved any changes or modifications to this device by
the user. Any changes or modifications could void the user’s authority to operate the equipment.
Le responsable de l’homologation de ce produit n’approuve aucune modification apportée à l’appareil par
l’utilisateur, quelle qu’en soit la nature. Tout changement ou modification peuvent annuler le droit d’utilisation
de l’appareil par l’utilisateur.
Wireless notice:
This device complies with FCC/ISED radiation exposure limits set forth for an uncontrolled environment and
meets the FCC radio frequency (RF) Exposure Guidelines and RSS‐102 of the ISED radio frequency (RF)
Exposure rules. This transmitter must not be co-located or operating in conjunction with any other antenna
or transmitter.
This device will be installed into specific carlines using three transmitting antennas. For all carlines,
antennas will be installed into three specific locations resulting in a distance much greater than 20 cm
between them. Each car passenger will only have one specific antenna near its seat:
- “Pin2/Ext.Antenna” will be installed always at a distance greater than 20 cm from any car passenger for all
carlines.
- “Pin3/Co-pilot” antenna will be installed at distances between 13.17 cm and more than 20 cm to the
closest car passenger depending on the carline model.
- “Pin4/Pilot” antennas will be installed at distances between 17.125 cm and more than 20 cm to the closest
car passenger depending on the carline model.
Le présent appareil est conforme à l'exposition aux radiations FCC / ISED définies pour un environnement
non contrôlé et répond aux directives d'exposition de la fréquence de la FCC radiofréquence (RF) et RSS‐
102 de la fréquence radio (RF) ISED règles d'exposition. L'émetteur ne doit pas être colocalisé ni
fonctionner conjointement avec à autre antenne ou autre émetteur.
Ce produit doit être installé de façon à garantir une distance minimale de séparation de 20 cm ou plus de
tout corps humain
CAN ICES-3 (B) / NMB-3 (B)
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de classe B est conforme à la norme canadienne ICES-003.
FCC Class B digital device notice
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
-
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and receiver.
-
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
-
Consult the dealer or an experienced radio/TV technician for help.