12
)
1
1.1
cover on the right side, then separate the terminal
connected to the top of the hinge
1.2
Use a crosshead screwdriver to loosen the hinge
screws. Remove the upper hinge
1.3
Move the door assembly upward to remove the door
assembly
2
2.1
cover on the left side of the cabinet. Install it into the
hole on the right side of the cabinet.
2.2
Remove the cover plate on the front of the cabinet
then pull the signal wire to the left side of the cabinet
2.3
Put the signal wire into the groove in the front cover
plate, and fasten it with the front cover plate
3
3.1
Dismantle the hinge shaft sleeve on the right side
and the cover on the left side of the door
3.2
Press the signal wire on the right side of the door into
the groove in the decorative strip, and close the
cover.
3.3
Pull out the signal wire from the groove in the left
side of the door, and push it into the hinge shaft
sleeve, then put it into the decorative strip
4
4.1
Dismantle the metal stopper cross-piece on the right
(Graphical representation in instruction booklet
last page.)
side of the door assembly, then install it in the corre
( & ).
-
sponding position on the left side of the door assem-
bly.
4.2
Use a crosshead screwdriver to remove the lower
hinge.
5
6
6.1
Install the door assembly onto the shaft on the
compartment assembly.
7
7.1
Take out the additional hinge and hinge cover from
the freezer drawer, and put the dismantled hinge and
hinge cover into a bag, and store them away.
7.2
Insert the hinge into the hole on the left side of the
door assembly, then use the screws to fasten the
hinge, and earth them by placing washers under-
neath the screws.
7.3
Connect the terminals on the cabinet to the terminals
on the door assembly, then fasten the hinge cover on.