Polycom COMMUNICATOR C100S Manuale utente

PO

LY

COM

®

COMMUNICATOR

MODEL NO. C100S

INSIDE FRONT COVER

(BLANK)

Polycom

®

Communicator User Guide - 1

Contents ........................................................... 1

English ............................................................. 2

Français .......................................................... 14

Deutsch .......................................................... 27

Italiano .......................................................... 40

Español........................................................... 53

Português ....................................................... 66

日本語 ............................................................. 79

简体中文 .......................................................... 93

Contents

Polycom

®

Communicator User Guide - 2

Introduction

Thank you for choosing the

Polycom

®

Communicator C100S.

The Polycom

®

Communicator

C100S connects to your

computer’s USB drive, giving you

full-duplex, two-way telephone

conversations over the Internet via

your Skype

™

account.

This package contains everything

you need to get started. If you are

missing any of the items shown

on this page, please contact your

reseller immediately.

Polycom

C100S Speakerphone

Carrying Case

August, 2011

PO

LY

COM

®

COMMUNICA

TO

R

CO

MMUNI

CA

TO

R

MODEL NO

. C1

00

S

User Guide

Setup Wizard CD

Polycom

®

Communicator User Guide - 3

Features

Keypad

LED light ring Volume up key

Application launch key

Volume down key

Call pickup/hangup key

Mute key

Speaker

Stereo headphone jack

(3.5mm)

Back cover/stand

USB cable

(Attached; located under

back cover/stand)

Microphone

Keypad

(See enlargement below)

Polycom

®

Communicator User Guide - 4

Setup

Insert the Setup Wizard CD

included with your package and

follow the onscreen instructions.

When prompted, connect the

Polycom

®

Communicator C100S

to the port on your computer in the

following manner:

Flip open the back cover of the

Polycom

®

Communicator C100S unit.

Unwind the USB cable.

Open up the back cover/stand

to its locked position.

(For best acoustic performance, the

unit is designed to stand at a 40º

angle to the surface it rests upon.)

Insert the USB cable of the unit

into a USB port on your computer.

When the unit has been connected,

complete the software and

hardware installation as per the

onscreen instructions.

LED Light Ring Indications

State Light Ring IndicationLED

Mute

Solid Red

Call on Hold

Solid Green

Incoming call

Flashing Green

Idle

Clear

Off hook, call being set up, or in an active call

Solid Green

Polycom

®

Communicator User Guide - 5

The Polycom

®

Communicator is

ready to use after completion of

software and hardware installation.

In order to use the Polycom

®

Communicator C100S, you will

need to have Skype

™

installed on

your computer. Go to www.skype.com

to download the latest version

of Skype

™

.

In order for the Polycom

®

Communicator C100S to function

properly, the microphone and

speaker volume (in Windows

Sounds and Audio Devices)

settings must not be set to “mute”.

The controls on the keypad allow

you to have basic call control

functionality:

Launch the Skype

™

application

Answer an incoming call

Hang up a completed call

Initiate a call with a selected

Skype

™

Contact

Volume Up

Volume Down

Mute

Getting Started

Polycom

®

Communicator User Guide - 6

With the Polycom

®

C100S

Manager, you can test for

microphone, speaker, and LED

functionality.

To launch the Polycom

®

C100S

Manager, double-click on the

Polycom

®

Communicator icon

on the desktop and click on the

Diagnostics Tools tab (see below).

Diagnostics

Polycom

®

Communicator User Guide - 7

In order to use this device, you

will also need to have one of

the following installed on your

computer: Microsoft

®

Windows

®

XP (SP 2), Windows

®

Vista, or Windows

®

7 OS.

For best acoustic performance,

always use the device with its back

cover/stand opened to the locked

position.

Ensure that the Polycom

Communicator is the device being

used for both microphone and

speaker.

For private conversations, stereo

headphones can be plugged into the

side of the Polycom

®

Communicator

C100S unit. If you have a set of

desktop PC speakers you can plug

them into the 3.5mm headphone

port on the side of the Polycom

C100S Speakerphone for stereo

sound.

You can use the Windows

®

Sounds

and Audio Devices screen to adjust

the volume of the microphones and

speaker.

Please note that the Polycom

Communicator automatically becomes

your default Windows Audio Device

(Mic & Speaker) when it is plugged

into your computer.

If you do not want the Polycom

Communicator to be your default Windows

Audio Device you can change your audio

settings by doing the following:

Select “Start” > “Settings” > “Control

Panel” > “Sounds and Audio Devices” >

“Audio” > then select your embedded sound

card from the drop-down menu for “Default

Audio Device”.

Tips

Polycom

®

Communicator User Guide - 8

If you make this change you will then

need to go to the Skype Application

and make Polycom Communicator

the default sound device for Skype

by doing the following:

Open the Skype Application and select

“Tools” > “Options” > “Audio Settings”.

You can then change the “Microphone”,

“Speakers” and “Ringing” settings to

the Polycom Communicator.

For additional information about the

Polycom

®

Communicator C100S or

other Polycom

®

products, visit

www.polycom.com.

For the most recent user

documentation and software visit

support.polycom.com/c100s.

Troubleshooting

If your Polycom

®

Communicator C100S

buttons do not provide call control as

described in this document, please try

one the following:

Open the Polycom

®

C100S Manager

and click the Diagnostics link to

access tools that enable veriﬁcation

of the device controls.

Verify that Skype is conﬁgured

to interact with the Polycom

Communicator C100S. Open the

Skype Application and select“Tools”

> “Options” >“Advanced” >”Manage

other programs’s access to Skype

Plug your Polycom

®

Communicator

C100S into a different USB port on

your PC.

Polycom

®

Communicator User Guide - 9

This device complies with part 15 of

the FCC rules. Operation is subject to

the following two conditions:

(1) This device may not cause harmful

interference, and

(2) This device must accept any

interference received, including

interference that may cause undesired

operation.

U.S. and Canada Regulatory and Compliance

Information

Part 15 Rules

You may also want to unplug your

Polycom

®

Communicator C100S,

reboot your computer and plug the

Polycom

®

Communicator C100S into

a different port.

For optimal audio experience ensure

that the Polycom Communicator

is the device being used for both

microphone and speaker.

Polycom

®

Communicator User Guide - 10

NOTE: This equipment has been

tested and found to comply with the

limits for a Class B digital device,

pursuant to part 15 of the FCC Rules.

These limits are designed to provide

reasonable protection against

harmful interference in a residential

installation. This equipment generates,

uses and can radiate radio frequency

energy and, if not installed and used

in accordance with the instructions,

may cause harmful interference to

radio communications. However, there

is no guarantee that interference will

not occur in a particular installation.

If this equipment does cause harmful

interference to radio or television

reception, which can be determined

by turning the equipment off and on,

the user is encouraged to try to correct

the interference by one or more of the

following measures:

Reorient or relocate the receiving

antenna.

Increase the separation between the

equipment and receiver.

Connect the equipment into an

outlet on a circuit different from that

to which the receiver is connected.

Consult the dealer or an experienced

radio/TV technician for help.

Class B Digital Device or Peripheral

Polycom

®

Communicator User Guide - 11

EEA (European Economic Area) including Swit-

zerland

This Polycom C100S Speakerphone has

been marked with the CE mark. This

mark indicates compliance with EEC

Directives 89/336/EEC and 73/23/

EEC. A full copy of the Declaration

of Conformity can be obtained from

Polycom Ltd, 270 Bath Road, Slough,

Berkshire, SL1 4DX, UK.

CE Mark LVD and EMC Directive

Modications

In accordance with part 15 of the FCC

rules, the user is cautioned that any

changes or modiﬁcations not expressly

approved by Polycom Inc. could void

the user’s authority to operate the

equipment.

Canadian EMC Class B

This Class [B] digital apparatus

complies with Canadian ICES -003.

Cet appareil numérique de la classe [B]

est conforme à la norme NMB-003 du

Canada.

Polycom

®

Communicator User Guide - 12

Warranty

This product comes with a limited one-year warranty.

Worldwide

Installation must be performed in accordance with all relevant national wiring

rules.

Installation Instructions

Japan

VCCI Class B

Polycom

®

Communicator User Guide - 13

August, 2011

PO

LY

COM

®

COMMUNICA

TO

R

CO

MMUNI

CA

TO

R

MODEL NO

. C1

00

S

Polycom

®

Communicator User Guide - 14

Introduction

Merci d’avoir choisi le Polycom

®

Communicator C100S.

En connectant le Polycom

®

Communicator C100S au port

USB de votre ordinateur, vous pouvez

avoir des conversations simultanées

et bidirectionnelles sur Internet par

l’intermédiaire de votre compte

Skype™.

Ce package contient tous les

éléments dont vous avez besoin

pour commencer. Si un des éléments

représenté sur cette page ne ﬁgure

pas dans le package, contactez

immédiatement votre revendeur.

Polycom

®

Communicator Guide de l’utilisateur

CD d’installation

Étui de transport

Polycom

®

Communicator User Guide - 15

Caractéristiques

Clavier

Voyant DEL Augmenter le

volume

Lancement de l’application

Baisser le volume

Répondre à un appel/

raccrocher

Couper le son key

Haut-parleur

Prise pour casque

stéréo (3,5 mm)

Dos/support

Câble USB

(fourni)

Microphone

Clavier

(voir l’agrandissement

ci-dessous)

Polycom

®

Communicator User Guide - 16

Insérez le CD d’installation inclus dans

le package et suivez les instructions

qui apparaissent à l’écran.

Lorsque vous y serez invité, branchez le

Polycom

®

Communicator C100S au

port de votre ordinateur de la manière

suivante :

Ouvrez le couvercle arrière

du Polycom

®

Communicator C100S.

Déroulez le câble USB.

Fixez le dos/support en position

ouverte (les meilleures performances

acoustiques de l’unité sont obtenues

lorsqu’elle est inclinée à un angle

de 40º par rapport à la surface sur

laquelle elle se trouve).

Insérez le câble USB de l’unité

dans un des ports USB de votre

ordinateur.

Une fois que l’unité est branchée,

poursuivez l’installation du logiciel

et du matériel selon les instructions

afﬁchées à l’écran.

Installation

Signiﬁcation des témoins lumineux

État Signification des témoins lumineux

Secret

Rouge fixe

Appel en attente

Vert fixe

Appel entrant

Vert clignotant

Inactif

Voyant éteint

Combiné décroché, appel en cours de configuration ou appel actif

Vert fixe

Polycom

®

Communicator User Guide - 17

Une fois l’installation logicielle

et matérielle terminée, le Polycom

®

Communicator est prêt à être utilisé.

Pour pouvoir utiliser le Polycom

®

Communicator C100S, Skype™ doit

être installé sur votre ordinateur. Pour

télécharger la dernière version de

Skype™, rendez-vous à la page www.

skype.com.

Pour que le Polycom

®

Communicator

C100S fonctionne correctement, les

paramètres de volume du microphone

et du haut-parleur (dans Windows,

Sons et multimédia) ne doivent pas

être réglés sur « Aucun son ».

Les commandes du clavier

vous permettent d’accéder aux

fonctionnalités de base de contrôle des

appels :

Lancer l’application Skype™

Répondre à un appel entrant

Raccrocher une fois l’appel terminé

Passer un appel avec un contact

Skype™ sélectionné

Augmenter le volume

Baisser le volume

Couper le son

Commencer l’utilisation

Polycom

®

Communicator User Guide - 18

Grâce au Gestionnaire Polycom

®

C100S, vous pouvez tester votre micro,

votre haut-parleur et votre voyant DEL.

Pour lancer le Gestionnaire Polycom

®

C100S, double-cliquez sur l’icône du

Polycom

®

Communicator sur le Bureau

et sélectionnez l’onglet Diagnostics

Tools (Outils de diagnostique) (voir

ci-dessous).

Diagnostique

La pagina sta caricando ...

Polycom COMMUNICATOR C100S Manuale utente

Polycom COMMUNICATOR C100S Manuale utente

in altre lingue

Documenti correlati

Altri documenti