GB
8
ASSEMBLING YOUR CLEANER
Remove all components from the packaging.
1. Release the securing latches to access the tank and take all components out.
2. Turn the tank upside down and attach the castors into the holes.
USING YOUR CLEANER
1. Ensure the product is correctly assembled together with the securing latches.
2. Connect the hose handle with telescopic tube.[1]
3. Assemble the accessories you require for the specic task.
4. The product is operated by switching the on/off switch.
5. To adjust the performance the suction regulator can be adjusted: [2]
Suction regulator open = reduced performance
Suction regulator closed = maximum performance
DRY VACUUMING
NOTE: After wet vacuuming, the appliance must be absolutely dry.
1. Ensure the pre-motor lter is tted correctly. Never dry vacuum without lters or
with damaged lters.
2. Remove the dam board and replace with a dust bag, ensure the dust bag is tted
correctly.[3]
3. Insert the hose end into the hose inlet, rotate the hose end clockwise until locked,
and connect the Carpet & Floor nozzle with the tube. [4]
4. Press the oor type selector on the nozzle [5] to select the ideal cleaning mode
for the oor type.
5. When the product loses suction, stop vacuuming and check the bag. Replace it if
necessary. A dust bag is essential when vacuuming ne dust (i.e. ashes, cement,
etc). However it is recommended for normal use as it not only improves the
retention of dust, but also protects both the motor and pre-motor lter.
WET VACUUMING
NOTE: Never use a dust bag or pre-motor lter when vacuuming liquids.
1. Release the securing latches , remove the motor top cover and replace the motor
lter with the sponge. [6]
2. Remove the dust bag and insert the dam board correctly in position on the main
body. [7]
3. Connect the wet nozzle to the tube. [8]
4. When the product oat activates and the cleaner loses performance, please stop
vacuuming and empty the tank.
5. Prolonged use after this time may cause damage.
6. Always empty, wash and dry the product after use.
NOTE: Ensure that the pre-motor lter is removed and put on sponge when vacuuming
liquids.