COMPATIBLE WITH
THE FOLLOWING ONLY:
1. Fill the plastic carbonating bottle with cold water up to the fill line.
WARNING! Do not carbonate anything other than water. Other
liquids can contaminate and clog internal parts, potentially
resulting in excessive pressure, bottle failure during carbonation
and serious injury. Never carbonate after flavoring has been
added.
2. To insert the plastic carbonating bottle, make sure that the bottle
rest is angled forward. Please make sure you do not pull the
carbonating tube. WARNING! Never use a Sparkling Water Maker
with a broken carbonating tube. This can cause excessive
pressure, bottle failure and serious injury. Insert the bottle neck
into the Snap-Lock system. Push the plastic carbonating bottle up
and back. The Snap-Lock will hold the plastic carbonating bottle.
3. To carbonate, press as follows to get the desired carbonation level:
• For 1L Plastic Carbonating Bottle: left button (one bubble) for light
fizz; Middle button (two bubbles) for medium fizz; Right button
(three bubbles) for strong fizz.
• For 0.5L Plastic Carbonating Bottle: Left button (one bubble) for
medium fizz; Middle button (two bubbles) for strong fizz.
4. The button will flash slowly indicating that it is carbonating and will
flash quickly when carbonation is complete. Pressing any button
during carbonation will stop the carbonation process. When the
desired level of carbonation is achieved, gently pull the Plastic
Carbonating Bottle towards you until it reaches its fully forward
position. This will release the pressure in the Plastic Carbonating
Bottle and allow the Plastic Carbonating Bottle to be released
from the Snap-Lock.
WARNING! Do not remove plastic carbonating bottle until after
hearing the sound of excess CO2 being released. Never force the
plastic carbonating bottle out of the Snap-Lock system. Always
allow the Sparkling Water Maker to release the plastic carbonating
bottle. If the plastic carbonating bottle does not immediately
release from the Snap-Lock system wait a few moments. If it still
does not release, then push the plastic carbonating bottle back
into the vertical position and gently pull it towards you again.
Attempting to remove the plastic carbonating bottle while it is
still pressurized can cause uncontrolled ejection of the plastic
carbonating bottle and may result in serious injury.
Note: when inserted correctly, there is
a small gap between the bottom of the
Plastic Carbonating Bottle and the
base. Do not carbonate if the Plastic
Carbonating Bottle is resting on the
base, or water will splash out.
Note: You may see small pieces of
ice appear in the water during
carbonation of very cold water. Any
ice created will simply melt.
SodaStream® plastic carbonating bottles
Check for compatibility
on the Bottle pack.
1L 0.5L 1L
CREATE THE BUBBLES
1
3
4
CARE
SPARKLING WATER MAKER CARE
• Never use abrasive cleaners or sharp tools to clean. If needed, use a mild liquid dish soap and a
soft damp cloth to gently clean.
• Wipe spills to keep base dry.
• Do not place in water or wash in a dishwasher, doing so will seriously damage your Sparkling
Water Maker.
PLASTIC CARBONATING BOTTLE
• For plastic carbonating bottles which are not "dishwasher safe", to clean, rinse
plastic carbonating bottle with cold or lukewarm water. WARNING! Do not expose to heat above
50°C/120°F. Never wash or rinse in hot water. Do not wash in dishwasher.
• For "dishwasher safe" plastic carbonating bottles, to clean, either wash in dishwasher or rinse
plastic carbonating bottle with cold or lukewarm water.
WARNING! Do not expose to heat above 70°C/158°F.
FOR YOUR SAFETY
SAVE THESE INSTRUCTIONS AND PROVIDE THEM TO ANY SUBSEQUENT USERS.
WARNING! Before using the Sparkling Water Maker, to reduce risk of personal injury and
damage to your product, please read this important safety information.
Before allowing anyone to use your Sparkling Water Maker, please be sure they understand how to
do so safely. Any servicing or repair should be performed by a SodaStream®-authorized service
representative.
The Sparkling Water Maker is only intended for use by people over the age of 12. People with
reduced physical or mental capabilities should only use the product if they are supervised by an
adult responsible for their safety and after they have been given instruction concerning the safe use
of the product.
TO REDUCE THE RISK OF EITHER SERIOUS INJURY OR DAMAGE TO THE SPARKLING
WATER MAKER DURING CARBONATION:
• Only use your Sparkling Water Maker in its upright position, on a flat, stable surface.
• Do not place your Sparkling Water Maker on a hot surface (e.g. kitchen oven/stove) and never use
it close to a flame or leave in direct sunlight.
• Carbonate water only.
• Do not add flavor before carbonation. Other liquids (except water) can contaminate and clog
internal parts, potentially resulting in excessive pressure and bottle failure during carbonation.
• Do not use the Sparkling Water Maker if the carbonating tube is broken or missing.
• Check that your plastic carbonating bottle is properly connected before carbonating.
• Do not move your Sparkling Water Maker or remove the plastic carbonating bottle during
carbonation.
• Do not carbonate an empty plastic carbonating bottle.
CARBON DIOXIDE CO2 CYLINDER
To reduce the risk of a CO2 leak, personal injury and property damage:
• Do not use any cylinder other than the SodaStream® CO2 Quick Connect Cylinder compatible with
the E-TERRATM Pink Handle System.
• Do not insert a CO2 Cylinder into the Sparkling Water Maker when a plastic carbonating
bottle is installed.
• Do not use if damaged. Inspect the CO2 Cylinder and CO2 Cylinder valve prior to use for dents,
punctures, or other damage. If damaged, contact a SodaStream-authorized service
representative.
• Do not tamper with the CO2 Cylinder in any way, including puncturing, incinerating or removing
the valve.
• Do not expose the CO2 Cylinder to heat above 50°C / 120°F. Protect from sunlight. Store in a well-
ventilated area.
• Do not remove a CO2 Cylinder from the Sparkling Water Maker when it is being operated.
• Do not handle or remove a CO2 Cylinder while it is discharging CO2.
• In the event of a CO2 leak, ventilate the area, breathe fresh air and if feeling unwell seek
immediate medical attention.
20