Lindy ExpressCard USB/FireWire Manuale utente

Categoria
Schede di interfaccia / adattatori
Tipo
Manuale utente
© LINDY ELECTRONICS LIMITED & LINDY-ELEKTRONIK GMBH - FIRST EDITION (May 2006)
FireWire 400 & USB 2.0
Combo ExpressCard
User Manual English
LINDY No. 51501
www.lindy.com
- 2 -
1. Introduction
Thank you for purchasing the LINDY FireWire 400 & USB 2.0 Combo ExpressCard.
With this card you can easily add one USB 2.0 and two IEEE1394a FireWire 400
ports to your notebook computer. The card features a 2.5Gbps ExpressCard/34
interface and supports IEEE 1394a FireWire transfer rates of 100, 200 & 400Mbps
and USB 2.0 transfer rates of 1.4, 12 and 480Mbps.
1.1. Features
1-lane 2.5Gbps ExpressCard/34 host interface
1.3mm DC power jack for optional 12V DC power adapter
Plug & Play support
1394a Interface
(FireWire 400)
Compliant with IEEE 1394 Open Host Controller Interface specification release 1.1
and IEEE 1394a-2000
Provides three 1394, 6 Pin FireWire ports, supporting speeds of 100/200/400 Mbps
Built-in FIFOs for isochronous transmit (2048 bytes), asynchronous transmit
(2048 bytes), and receive (3072 bytes)
32-bit CRC generation and checking for receive/transmit packets
USB 2.0 Interface
Compliant with Universal Serial Bus Specification Revision 2.0 (Data Rate 1.5/ 12/
480 Mbps)
Compliant with the Open Host Controller Interface Specification for USB Rev 1.0a
Compliant with Enhanced Host Controller Interface Specification for USB Rev 0.95
All USB ports can handle high-speed (480 Mbps), full-speed (12 Mbps), and
low-speed (1.5 Mbps) transfer rates
DC Jack Power Input
Power Input: 12V / 1A
Polarity: Center --- Positive Power (V+), Outer --- Power Return (V-)
Power Plug: 3.5 x 1.3 x 9mm
1.2. Package Contents
FireWire 400 & USB 2.0 Combo ExpressCard
This manual
- 3 -
2. Software Installation
To use the FireWire 400 & USB 2.0 Combo ExpressCard, the host computer must be
equipped with one free ExpressCard slot.
2.1. Windows 2000 installation
1. Insert the card into an available ExpressCard slot
2. When the wizard indicates that it has found a driver for the device, click 'Next'
3. The wizard will now copy the required files to the system and start the driver. After
starting the driver, the wizard will display a completion dialog. Click 'Finish' to exit
the wizard.
2.2. Windows XP installation
1. Insert the card into an available ExpressCard slot
2. When the wizard indicates that it has found a driver for the device, click 'Next'.
3. The wizard will now copy the required files to the system and start the driver. After
starting the driver, the wizard will display a completion dialog. Click 'Finish' to exit
the wizard.
2.3.
Verifying the installation under Windows 2000 and XP
Follow the instructions in this section to verify that the controller was installed correctly.
1. Right click the 'My Computer' icon, select 'Properties', left click on the 'Hardware' tab
and then on the 'Device Manager' button.
2. Double click on 'IEEE 1394 Bus host Controllers', if there is no yellow '!' or '?' in front
of 'Texas Instruments OHCI Compliant IEEE 1394 Host Controller', the driver has
started correctly.
3. To view information about the devices attached to the controller, right click on 'Devices'
and select 'Properties' from the context menu, then select the tab labelled
'General'.
- 4 -
2.4. Windows 98SE installation
1. Insert the card into an available ExpressCard slot
2. The Hardware Wizard will display that it has found a 'Texas Instruments OHCI
Compliant IEEE 1394 Host Controller'. Click 'Next'.
3. Select 'Search for the best driver for your device [Recommended]' and click 'Next'.
4. Make sure that only the 'Floppy disk drives' checkbox is checked and click 'Next'.
5. Select the ‘Updated driver (Recommended)' option and choose ‘Texas
Instruments OHCI Compliant IEEE 1394 Host Controller’. Click 'Next' and 'Next'
again to continue.
6. If 'Insert Disk' is displayed, insert your Windows 98SE CD and clickOK'. Click
'Finish' to exit the wizard.
2.5. Windows ME installation
1. Insert the card into an available ExpressCard slot
2. The Hardware Wizard will display that it has found a 'Texas Instruments OHCI
Compliant IEEE 1394 Host Controller'. Select 'Automatically search for a
better driver (Recommended)'. Click 'Next'.
3. The system will go through the enumeration process and install the driver. At the end of
the process, click 'Finish' to complete the installation.
2.6.Verifying the installation under Windows 98SE and ME
Follow the instructions in this section to verify that the controller was installed correctly.
1. Right click the 'My Computer' icon, select 'Properties', and left click on 'Device
Manager' tab.
2. Double click on '1394 Bus Controllers'. If there is no yellow '!' or '?' in front of 'Texas
Instruments OHCI Compliant IEEE 1394 Host Controller', the driver has started
correctly.
3. To view information about the devices attached to the controller, right click on 'Devices'
and select 'Properties' from the context menu then select the tab labelled
'General'.
- 5 -
WEEE (Waste of Electrical and Electronic Equipment), Recycling of Electronic Products
United Kingdom
In 2006 the European Union introduced regulations (WEEE) for the collection and recycling of all waste electrical and electronic
equipment. It is no longer allowable to simply throw away electrical and electronic equipment. Instead, these products must enter
the recycling process.
Each individual EU member state has implemented the WEEE regulations into national law in slightly different ways. Please follow
your national law when you want to dispose of any electrical or electronic products.
More details can be obtained from your national WEEE recycling agency.
Germany / Deutschland
Die Europäische Union hat mit der WEEE Direktive umfassende Regelungen für die Verschrottung und das Recycling von Elektro-
und Elektronikprodukten geschaffen. Diese wurden von der Bundesregierung im Elektro- und Elektronikgerätegesetz – ElektroG in
deutsches Recht umgesetzt.
Dieses Gesetz verbietet vom 24.März 2006 an das Entsorgen von entsprechenden, auch alten, Elektro- und Elektronikgeräten über
die Hausmülltonne! Diese Geräte müssen den lokalen Sammelsystemen bzw. örtlichen Sammelstellen zugeführt werden! Dort
werden sie kostenlos entgegen genommen. Die Kosten für den weiteren Recyclingprozess übernimmt die Gesamtheit der
Gerätehersteller.
France
En 2006, l'union Européenne a introduit la nouvelle réglementation (WEEE) pour le recyclage de tout équipement électrique et
électronique.
Chaque Etat membre de l’ Union Européenne a mis en application la nouvelle réglementation WEEE de manières légèrement
différentes. Veuillez suivre le décret d’application correspondant à l’élimination des déchets électriques ou électroniques de votre
pays.
Italy
Nel 2006 l’unione europea ha introdotto regolamentazioni (WEEE) per la raccolta e il riciclo di apparecchi elettrici ed elettronici. Non
è più consentito semplicemente gettare queste apparecchiature, devono essere riciclate.
Ogni stato membro dell’ EU ha tramutato le direttive WEEE in leggi statali in varie misure. Fare riferimento alle leggi del proprio
Stato quando si dispone di un apparecchio elettrico o elettronico.
Per ulteriori dettagli fare riferimento alla direttiva WEEE sul riciclaggio del proprio Stato.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operations.
1 / 1