Always wear protective gear and observe safety precautions when installing the FastTrack system.

Plan/Excavate

Excavate a trench for the FastTrack, considering both load

class and slab thickness. All channels must be encased

on three sides with a minimum of 4" of concrete. For

slabs thicker than 4", encasement must be equal to slab

thickness. The engineer should determine slab thickness

Concrete encasement is required regardless of surface

type (concrete, asphalt, pavers, etc.).

saw. Attach the end outlet with screws to the deep end

and the end cap on the shallow end. If using an end outlet,

outlet and pipe.

For Bottom Outlet: Using a hole saw, open the bottom

outlet in the deep end and install end caps on

both the deep and shallow ends.

Assemble Channels

Set channel sections in order into the trench. Beginning

at the outlet end, connect the channels together using

silicone sealant in the groove if desired.

MIN

Trench Drain Installation Guide

Cover Joint

Channel Joint

Anchor with Rebar

Beginning at the outlet end, install rebar into the anchor

clips on either side of the channel and drive rebar into the

ground. Adjust channel vertically to the proper elevation,

checking for level and alignment using the string line as a

guide. The top of the channel should be set 1/16" to 1/8"

with rebar and screws (wire) in ALL available anchor clips

to keep the run as secure as possible. Be Sure:



Channels will be encased in 4" of concrete (min.)



Expansion joints will be installed on each side



Connect drain piping to the channel outlet according to

plans using a No-Hub coupling.

sure channels and drain piping are free of debris. Set

appropriate grating in place and secure the grates into

the grate anchors using screws.