Ericsson DT288 Manuale utente

DECT GAP/CAP

User’s Guide

EN/LZTNB 101 179 R2

Cordless Phone Set DT288

2

This user’s guide consists of several sections and topics which can be read

individually. You will find each section and topic listed in the table of contents.

In addition, the “Index” at the back of this guide shows where to find help on

each topic. To get the cordless phone up and running and information about

basic use of the cordless phone, you should read the “Getting started” section

in particular. Other parts can be read when needed.

This user’s guide is published by Ericsson Business Mobile Networks BV,

without any warranty. Improvements and changes to this user’s guide neces-

sitated by typographical errors, inaccuracies of current information, or

changes to programs and/or equipment, may be made by Ericsson Business

Mobile Networks BV at any time and without notice. Such changes will, how-

WHAT TO READ FIRST

ABOUT THIS USER’S GUIDE

3

Note

This user’s guide describes the most important features of the DT288 cord-

less phone. Since the DT288 cordless phone can be used in several networks

supporting different capabilities, some of the features might not be usable in

your network.

• GAP/CAP compliant

• Calling line identification (depending on the network)

• Phone book for 100 names and numbers

• Up to 100 hours stand-by time and up to 15 hours talk time

• Menu in 11 languages

• Side keys for volume

• Who called list for 10 numbers

• Last dialled list for 10 numbers

CORDLESS PHONE FEATURES

4

CORDLESS PHONE

Earpiece

Volume up key

Volume down key

Off hook key

Clear/Mute key

On Hook/On/Off key

R key

Internal call key

Up key

Down key

Microphone

Battery compartment (rearside)

Warning light

Number keys

Display

Antenna

5

For further details, please see section “Reference” on page 114.

CORDLESS PHONE DISPLAY ICONS AND INDICATORS

On Flashing Flashing quickly

Signal strength Visible when connected

to a network

Ring off Ring signal muted or

microphone off

Key Keys locked

Hook Cordless phone off hook Connection being made Cordless phone is ringing

Message Message waiting

Call Info New unanswered entry

in the who called list

Battery Battery status (4 blocks

is fully charged)

Battery casing flashes;

battery almost empty

Blocks flash succes-

sively; battery is being

charged (steady blocks

indicate the battery level)

Warning light Warning (battery low/no

connection)

Incoming call

Message waiting

Content 6

Content

Getting started 8

Check for completeness 8

Preparing for use 10

Battery 15

Clip 19

Switching on the cordless phone 21

Menu structure 23

Using the menus 26

Making and receiving calls 29

Changing the menu language 31

Looking up the IPEI code 32

Switching off the cordless phone 34

Telephone networking in short 34

Telephoning 37

Information on display 37

Making a call 40

Call using the phone book 41

Redialling 44

Returning a call 46

Receiving a call 48

Transferring a call 49

Turning off the microphone 52

Turning off the ringer 53

Advanced telephoning 55

Internal, external call or call back? 55

Paging and message waiting 56

Changing the dialling mode 57

Setting long tones 58

Sending a dial tone pause 59

Baby phone 59

Direct call 60

Call statistics cordless phone 62

Content 7

Phone book 63

Phone book use 63

Adding name and number 66

Editing name and number 67

Deleting name and number 69

Adding last dialled numbers 70

Adding caller’s number 72

Blocking keys and extra

security 74

Key lock 74

Cordless phone lock 76

Changing the PIN code 79

Unblocking the cordless phone 80

Overview PIN and other codes 82

Settings 83

Volume control 83

Ringer tones or melodies 86

Discreet ringing 88

Key click 89

Display light 90

Display contrast 91

Language 92

AutoIntern 92

Clearing all cordless phone settings 93

Networking 94

Connecting to telephone networks 94

Subscribing to a network 97

Resubscribing to a network 103

Selecting a network automatically 103

Selecting a network manually 105

Editing network name 106

Deleting network subscription 108

Changing subscription priority 109

Tips and tricks 111

Reference 114

Safety instructions 114

Troubleshooting 116

Buttons and keys 121

Terminology 123

Signals 124

Maintenance 125

Technical specifications 127

Spare parts and accessories 131

Index 132

Getting started 8

Getting started

Make sure that all the parts are present. If anything is missing, please contact

your system manager or supplier.

The set contains:

1. Cordless phone

2. Battery

3. Clip

4. Charger

5. Charger adapter

6. Wall mount including fixation plugs and screws

7. Desk stand

CHECK FOR COMPLETENESS

Getting started 9

8. Quick Reference Guide

9. Assembly card

Note

It is important to make a note of the IPEI code. The IPEI code may be needed

for unblocking the cordless phone if an incorrect PIN code has been entered

three times. Refer to “Looking up the IPEI code” on page 32 for further details.

Getting started 10

When using the cordless phone for the first time, follow the steps below to

prepare the cordless phone.

Warnings

• Do not use the equipment in conditions where there is a danger of electri-

cally ignited explosions.

• Do not expose the equipment to direct sunlight for long periods.

• Keep the equipment away from excessive heat and moisture.

• Make sure the local mains voltage corresponds to the voltage on the

charger.

Note

Only use the charger that comes with the cordless phone.

PREPARING FOR USE

Getting started 11

1. Attach the clip to the cordless phone. Do not press on the display!

2. Place the battery as shown below. Make sure that the battery wires are

put through the notches as shown.

Getting started 12

Getting started 13

3. Connect the mains adapter to the charger and connect it to the mains out-

let.

If you place the charger on a wall, screw the wall mount to the wall.

4. Place the cordless phone in the charger to charge the battery.

Getting started 14

Complete charging before you subscribe or use the cordless phone. The

green light of the charger is turned off when charging is completed. For more

information about charging the battery, please refer to “Battery” on page 15.

Getting started 15

5. Subscribe the cordless phone to the telephone network. Follow the proce-

dure in “Subscribing to a network” on page 97.

When the cordless phone is subscribed to a telephone network, the cordless

phone is ready for use. See also “Telephone networking in short” on page 34.

The cordless phone is powered by a rechargeable battery. You can fully

charge a flat battery by placing the cordless phone in the charger for 3 hours.

A fully charged battery gives you up to 15 hours calling time or up to 150

hours stand-by time. The cordless phone has a battery meter, which indicates

the power left in the battery.

Note

The cordless phone is powered by a Nickel Metal Hydride (NiMH) battery. It

can be recharged at any time. To keep the battery fully charged, you can put

or leave the cordless phone in the charger without any problem.

BATTERY

Getting started 16

Reading the battery meter

When the battery is fully charged, the battery meter on the cordless phone

display consists of four blocks. The number of blocks decreases as the bat-

tery discharges. If the battery is almost flat, the battery meter and the red light

on the cordless phone flash. An alarm sounds if there is less than 15 minutes

calling time left in the battery.

Charging the battery

Place the cordless phone in the charger as shown in the picture below.

Getting started 17

If the lower green light on the charger is on (and the battery meter on the dis-

play flashes), the battery in the cordless phone is being charged. As soon as

the battery is fully charged, the lower green light is turned off and the battery

meter on the cordless phone stops flashing.

Getting started 18

If the battery is completely flat it can take a few minutes before the lower

green light on the charger comes on.

Changing the battery

Rechargeable batteries have a limited lifespan.

If the stand-by time for the cordless phone becomes too low, you should

replace the battery. Please contact your system manager or supplier for more

information.

Warning

Only use batteries as specified in “Technical specifications” on page 127.

The battery does not contain cadmium and is therefore more environmentally-

friendly than other rechargeable batteries. However, all batteries should be

treated as chemical waste.

Getting started 19

The cordless phone has a clip to attach the cordless phone to your clothes.

• How to attach the clip to the cordless phone: see “Preparing for use” on

page 10 for specific instructions.

• How to remove the clip from the cordless phone: see the drawing below.

Note

To minimize wear and tear, we recommend that you do not remove the clip

from the cordless phone too often.

CLIP

Getting started 20

Remove the clip

La pagina sta caricando ...

Ericsson DT288 Manuale utente

Ericsson DT288 Manuale utente

in altre lingue

Documenti correlati

Altri documenti