udi R C UDI017 Guida utente

Marca: udi R C

Modello: UDI017

Tipo: Guida utente

Questo manuale è adatto anche per

UDI017 2.4Ghz High Speed RC Boat

UDI017

This product is suitable for users over 14 years old.

Stay away from the rotating propeller

Read the “important statement and safety guidelines” carefully.

Note

https://udirc.com/disclaimer-and-safety-instructions

Suitable for sailing in larger waters

Li-Po Battery Disposal & Recycling

Wasted Lithium-Polymer batteries must not be placed with household

trash. Please contact local environmentalor waste agency or the

supplier of your model or your nearest Li-Po battery recycling center.

Our company's products are improving all the time, design and specifications are

subject to change without notice. All the information in this manual has been

carefully checked to ensure accuracy, if any printing errors, our company reserve

the final interpretation right.

Important

Notice

OPERATION GUIDE

Deck

Hull bottom

Outlet

Cabin outer cover

Outer cover lock

Tail rudder

Propeller

Spindle tube

Support bracket

Power Switch

Buckle

Left navigation

Right navigation

Navigation Lights Cover

Navigation Lights

Battery Compartments

Tail rudder Bracket

Rods

Ready before sailing

Preparation the boat

Battery Charge

Water press pieces

Connect the charging case to the charging input port of the boat battery and then connect the USB

output ports. The green indicator light flashes when charging and the green indicator light will keep

bright fully charged. During the charging, battery should not be placed in the hull when charging and

must be cooled before charging.

USB adapter (Not Include)

Battery power is insufficient in the original plant. It must be charged saturated before it can be used.

②①

Battery

input port Charger for Li battery case

powercharging

Boat battery

Warning: Must be supervised while charging

Please use the included USB charging cable and make sure it is properly connected.

Boat battery installation method

1) Twist to left or right to open the outer cover lock. 2) Open up the cabin cover.

3) According to the mark on the surface of the inner cover, unlock the lock and take out the inner

cover upward.

Cabin Inner

Cover

4) Put the Li-po battery into the boat battery holder.

the power line of the battery puts on the side of the

hull, push the battery to the end and stick to it.

6) Cover the inside and outside of the cabin and lock tightly.

Head Cover Installation

Align the head cover with the bottom hole of the boat and install it in the right place.

5) Properly connected the hull input port

to the output port of the Boat battery.

Battery output port Hull input port

Navigation Lights Installation

Transmitter Preparation

Steering Knob

Throttle Trigger

Forward Trim

Backward Trim

Power Indicator

Left Rudder Trim

Right Rudder Trim

Power Switch

Battery installation of transmitter

Battery Cover

Bottom of Transmitter

4×1.5V AA, Alkaline Batteries

Open the transmitter battery cover.

Install batteries. Follow the direction

of batteries designated in the inside

of the battery box.

Note Direction.

1) Press the buckle inward

2) Take out navigation

lights cover

Back of

cabin cover

Press the " " to turn on the power.

Press again to select different lights.

Long press the switch for 2 senconds

to turn off the power.

3) Press the navigation

light into the corresponding

buckle position.

Buckle

position.

When the navigation light in low battery,

the lamp will keep flashing. It indicates the

operator to replace the battery.

Please make sure the transmitter throttle stick and rudder knob to

normal.

It is recommended to be familiar with the operation on the surface

of the water before long distance navigation.

Sailing Operation

Frequency Pairing

How to Operate the Boat

To move Forward

Pull back the throttle trigger of the

transmitter. The boat moves forward.

To move Backward

Push forward the throttle trigger

of the transmitter. The boat moves

backwards.

To turn Left

Pull back the throttle trigger of the

transmitter and move the steering

knob counterclockwise, then the

boats turns left.

To turn Right

Pull back the throttle trigger of the

transmitter and move the steering knob

clockwise then the boat turns right.

Self-Righting Hull

If the boat capsizes, Push forward and

backward the throttle trigger of the

transmitter and then pull back at once.

The boat will then return to normal, the

capsize reset function will turn off

automatically when the boat in low battery.

1) Power on the transmitter, will sound “di”, and the indicator light

flashes, then to enter frequency pairing.

2) After the boat battery is installed and powered on, tighten the hatch

cover.

3) Put the boat into the water, the transmitter will sound “didi”, and the

indicator will keep long bright it means frequency pairing successful.

Trimmer

If the boat drifts to the right, press the left

rudder trim on the transmitter and the boat

will gradually correct the rudder alignment.

It will start moving straight.

If the boat drifts to the left, press the right

rudder trim on the transmitter and the boat

will gradually correct therudder alignment.

It will start moving straight.

Left Rudder Trim

Right Rudder Trim

If the boat still moves backwards when the

throttle trigger is in the middle position,

press forward trim until the boat stops going

backwards.

Forward trim

If the boat still moves forward when the

throttle trigger is in the middle position,

press backward trim until the boat stops

going forward.

Backward Trim

Low Battery Alarm

Out of Range Alarm

The motor lowers the temperature by flowing water. During the voyage, water flows through the

heat pipe around the motor, which has a cooling effect on the motor.

Water cooling system

Only when the boat is in the water can it work normally. Stop working after leaving the water surface,

prevent misoperation and play a role of safety protection.

Out of water protection

Boat: When the boat in low battery, the transmitter will beep “di.di.di. ...” constantly to remind the

user to remote back the boat as soon as possible. And the boat speed will slow down to half

and the capsize reset function will turn off automatically when the boat in low battery.

Transmitter: When the transmitter in low battery, the transmitter will beep “di.di.di. ...” to remind

the user to remote back the boat to replace the batteries as soon as possible.

When the boat is running out of the max remote control distance, the transmitter will beep

“didi...didi...” to alarm the user to remote back the boat immediately.

Propeller Replacement

Parts Replacement

Safety Precautions

1) Turn on the transmitter power first and then turn on the boat power before playing; Turn off the

boat power first and then turn off the transmitter power when finish playing.

2) Make sure the connection is solid between battery and motor etc. The ongoing vibration may

cause bad connection of power terminal.

3) Improper operation may cause impact to the boat and damage the hull or propeller.

4) It is forbidden to sail in the water where people are useful and sail away from salt water and

sundry water.

5) The battery must be take out after playing to keep the cabin dry and clean.

Troubleshooting Guide

Remove:

Unscrew the nut and take out the propeller.

Installation:

Insert the propeller and tighten nut.

Problem

The transmitter

indicator light

is off

Solution

Unscrew

Take out

①

②

The boat tilts

to one side

1) Make sure whether the propeller is damaged or replace a new one.

4) Make sure whether the motor is damaged or replace a new one.

1) Operate according to the “trimmer” as per instructions.

2) Calibrate the steering gear arm.

3) The steering gear is damaged, replace a new one.

Unable to

frequency

The boat is

under-powered

or can not go

forward

1) Replace the transmitter battery.

1) Operate the boat step by step in accordance with the user manual.

2) Make sure signal interference nearby and keep away.

3) The electronic component is damaged for frequent crash.

2) When the battery is low, charger it in time. Or replace it with a new battery.

3) Make sure install the propeller correctly.

2) Please make sure the battery is installed correctly.

4) Please make sure turn on the power.

3) Clean the dirt from metal contacts in battery groove.

FCC Note

WARNING

Warning: The product should only be used by adults and children over 14 years.

Adult supervision is required for children under 14 years.

Hinweis: Dieses Produkt ist für die Erwachsene und die Kinder ab 14 Jahren.

Die kinder unter 14 Jahren müssen von Erwachsenen beaufsichtigt werden.

Avertissement: Ce produit est destiné aux adultes et aux enfants de plus de 14 ans.

Les enfants de moins de 14 ans doivent être surveillés par des adultes.

Avvertimento: Questo prodotto è destinato all'uso per i adulti e bambini di età superiore ai 14 anni.

I bambini di età inferiore ai 14 anni devono essere sorvegliati da un adulto.

Advertencia: Este producto es para adultos y niños mayores de 14 años.

Los niños menores de 14 años deben ser supervisados por adultos.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the

FCC Rules. These limits are designed to provide reasonable protection against harmful interferencein a residential installation.

This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will

not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which

can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or

more of the following measures:

Reorient or relocate the receiving a ntenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which thereceiver is connected.

WARNING: Changes or modifications not expressly approved by the party responsible for compliance could

void the user's authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference.

(2) This device must accept any interference received, including interference that may cause undesired operation.

The equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful

interference unless the modifications are expressly approved in the instruction manual. Modifications not authorized by the

manufacturer may void user’s authorityto operate this device.

The device has been evaluated to meet general RF exposure requirement.

The device can be used in portable exposure condition with out restriction.

FCC Radiation Exposure Statement

Address: Guangfeng Industrial Zone, Guangyi Street, Chenghai District, Shantou City, Guangdong Province, CN

Manufacturer: SHANTOU CITY CHENGHAI UDIRC TOYS CO., LTD

Model: UDI017 Manufacture time:

MADE IN CHINA

DANGER!

Only suitable for age 14+

udi R C UDI017 Guida utente

Marca: udi R C

Modello: UDI017

Tipo: Guida utente

Questo manuale è adatto anche per

UDI017 2.4Ghz High Speed RC Boat

Scarica il pdf

rapporto

in altre lingue

English: udi R C UDI017 User guide

udi R C UDI017 Guida utente

Questo manuale è adatto anche per

udi R C UDI017 Guida utente

in altre lingue

Altri documenti