UDI017
This product is suitable for users over 14 years old.
Stay away from the rotating propeller
Read the “important statement and safety guidelines” carefully.
Note
https://udirc.com/disclaimer-and-safety-instructions
Suitable for sailing in larger waters
Li-Po Battery Disposal & Recycling
Wasted Lithium-Polymer batteries must not be placed with household
trash. Please contact local environmentalor waste agency or the
supplier of your model or your nearest Li-Po battery recycling center.
Our company's products are improving all the time, design and specifications are
subject to change without notice. All the information in this manual has been
carefully checked to ensure accuracy, if any printing errors, our company reserve
the final interpretation right.
Important
Notice
OPERATION GUIDE
01
Deck
Hull bottom
Outlet
Cabin outer cover
Outer cover lock
Tail rudder
Propeller
Spindle tube
Support bracket
Power Switch
Buckle
Left navigation
Right navigation
Navigation Lights Cover
Navigation Lights
Battery Compartments
Tail rudder Bracket
Rods
Ready before sailing
Preparation the boat
Battery Charge
Water press pieces
Connect the charging case to the charging input port of the boat battery and then connect the USB
output ports. The green indicator light flashes when charging and the green indicator light will keep
bright fully charged. During the charging, battery should not be placed in the hull when charging and
must be cooled before charging.
USB adapter (Not Include)
Battery power is insufficient in the original plant. It must be charged saturated before it can be used.
②①
Battery
input port Charger for Li battery case
powercharging
Boat battery
Warning: Must be supervised while charging
Please use the included USB charging cable and make sure it is properly connected.
02
Boat battery installation method
1) Twist to left or right to open the outer cover lock. 2) Open up the cabin cover.
3) According to the mark on the surface of the inner cover, unlock the lock and take out the inner
cover upward.
Cabin Inner
Cover
4) Put the Li-po battery into the boat battery holder.
the power line of the battery puts on the side of the
hull, push the battery to the end and stick to it.
6) Cover the inside and outside of the cabin and lock tightly.
Head Cover Installation
Align the head cover with the bottom hole of the boat and install it in the right place.
5) Properly connected the hull input port
to the output port of the Boat battery.
Battery output port Hull input port
03
Navigation Lights Installation
Transmitter Preparation
Steering Knob
Throttle Trigger
Forward Trim
Backward Trim
Power Indicator
Left Rudder Trim
Right Rudder Trim
Power Switch
Battery installation of transmitter
Battery Cover
Bottom of Transmitter
4×1.5V AA, Alkaline Batteries
Open the transmitter battery cover.
Install batteries. Follow the direction
of batteries designated in the inside
of the battery box.
Note Direction.
1) Press the buckle inward
2) Take out navigation
lights cover
Back of
cabin cover
Press the " " to turn on the power.
Press again to select different lights.
Long press the switch for 2 senconds
to turn off the power.
3) Press the navigation
light into the corresponding
buckle position.
Buckle
position.
When the navigation light in low battery,
the lamp will keep flashing. It indicates the
operator to replace the battery.
04
Please make sure the transmitter throttle stick and rudder knob to
normal.
It is recommended to be familiar with the operation on the surface
of the water before long distance navigation.
Sailing Operation
Frequency Pairing
How to Operate the Boat
To move Forward
Pull back the throttle trigger of the
transmitter. The boat moves forward.
To move Backward
Push forward the throttle trigger
of the transmitter. The boat moves
backwards.
To turn Left
Pull back the throttle trigger of the
transmitter and move the steering
knob counterclockwise, then the
boats turns left.
To turn Right
Pull back the throttle trigger of the
transmitter and move the steering knob
clockwise then the boat turns right.
Self-Righting Hull
If the boat capsizes, Push forward and
backward the throttle trigger of the
transmitter and then pull back at once.
The boat will then return to normal, the
capsize reset function will turn off
automatically when the boat in low battery.
1) Power on the transmitter, will sound “di”, and the indicator light
flashes, then to enter frequency pairing.
2) After the boat battery is installed and powered on, tighten the hatch
cover.
3) Put the boat into the water, the transmitter will sound “didi”, and the
indicator will keep long bright it means frequency pairing successful.
05
Trimmer
If the boat drifts to the right, press the left
rudder trim on the transmitter and the boat
will gradually correct the rudder alignment.
It will start moving straight.
If the boat drifts to the left, press the right
rudder trim on the transmitter and the boat
will gradually correct therudder alignment.
It will start moving straight.
Left Rudder Trim
Right Rudder Trim
If the boat still moves backwards when the
throttle trigger is in the middle position,
press forward trim until the boat stops going
backwards.
Forward trim
If the boat still moves forward when the
throttle trigger is in the middle position,
press backward trim until the boat stops
going forward.
Backward Trim
Low Battery Alarm
Out of Range Alarm
The motor lowers the temperature by flowing water. During the voyage, water flows through the
heat pipe around the motor, which has a cooling effect on the motor.
Water cooling system
Only when the boat is in the water can it work normally. Stop working after leaving the water surface,
prevent misoperation and play a role of safety protection.
Out of water protection
Boat: When the boat in low battery, the transmitter will beep “di.di.di. ...” constantly to remind the
user to remote back the boat as soon as possible. And the boat speed will slow down to half
and the capsize reset function will turn off automatically when the boat in low battery.
Transmitter: When the transmitter in low battery, the transmitter will beep “di.di.di. ...” to remind
the user to remote back the boat to replace the batteries as soon as possible.
When the boat is running out of the max remote control distance, the transmitter will beep
“didi...didi...” to alarm the user to remote back the boat immediately.
06
Propeller Replacement
Parts Replacement
Safety Precautions
1) Turn on the transmitter power first and then turn on the boat power before playing; Turn off the
boat power first and then turn off the transmitter power when finish playing.
2) Make sure the connection is solid between battery and motor etc. The ongoing vibration may
cause bad connection of power terminal.
3) Improper operation may cause impact to the boat and damage the hull or propeller.
4) It is forbidden to sail in the water where people are useful and sail away from salt water and
sundry water.
5) The battery must be take out after playing to keep the cabin dry and clean.
Troubleshooting Guide
Remove:
Unscrew the nut and take out the propeller.
Installation:
Insert the propeller and tighten nut.
Problem
The transmitter
indicator light
is off
Solution
Unscrew
Take out
①
②
The boat tilts
to one side
1) Make sure whether the propeller is damaged or replace a new one.
4) Make sure whether the motor is damaged or replace a new one.
1) Operate according to the “trimmer” as per instructions.
2) Calibrate the steering gear arm.
3) The steering gear is damaged, replace a new one.
Unable to
frequency
The boat is
under-powered
or can not go
forward
1) Replace the transmitter battery.
1) Operate the boat step by step in accordance with the user manual.
2) Make sure signal interference nearby and keep away.
3) The electronic component is damaged for frequent crash.
2) When the battery is low, charger it in time. Or replace it with a new battery.
3) Make sure install the propeller correctly.
2) Please make sure the battery is installed correctly.
4) Please make sure turn on the power.
3) Clean the dirt from metal contacts in battery groove.
07
FCC Note
WARNING
Warning: The product should only be used by adults and children over 14 years.
Adult supervision is required for children under 14 years.
Hinweis: Dieses Produkt ist für die Erwachsene und die Kinder ab 14 Jahren.
Die kinder unter 14 Jahren müssen von Erwachsenen beaufsichtigt werden.
Avertissement: Ce produit est destiné aux adultes et aux enfants de plus de 14 ans.
Les enfants de moins de 14 ans doivent être surveillés par des adultes.
Avvertimento: Questo prodotto è destinato all'uso per i adulti e bambini di età superiore ai 14 anni.
I bambini di età inferiore ai 14 anni devono essere sorvegliati da un adulto.
Advertencia: Este producto es para adultos y niños mayores de 14 años.
Los niños menores de 14 años deben ser supervisados por adultos.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interferencein a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving a ntenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which thereceiver is connected.
WARNING: Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired operation.
The equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful
interference unless the modifications are expressly approved in the instruction manual. Modifications not authorized by the
manufacturer may void user’s authorityto operate this device.
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition with out restriction.
FCC Radiation Exposure Statement
Address: Guangfeng Industrial Zone, Guangyi Street, Chenghai District, Shantou City, Guangdong Province, CN
Manufacturer: SHANTOU CITY CHENGHAI UDIRC TOYS CO., LTD
Model: UDI017 Manufacture time:
MADE IN CHINA
DANGER!
Only suitable for age 14+
08
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
udiR C UDI017 Guida utente
- Tipo
- Guida utente
- Questo manuale è adatto anche per
in altre lingue
- English: udiR C UDI017 User guide
Documenti correlati
Altri documenti
-
Udirc UDI008 Remote Control Boat Guida utente
-
ProBoat Impulse 31 PRB4250B Manuale utente
-
Kyosho No.40235S@HURRICANE 900 VE Manuale utente
-
-
-
-
ProBoat Shockwave 26 Manuale utente
-
-
-
ProBoat React 17" Self-Righting Brushed Deep-V RTR Manuale del proprietario
