SATA Adapter for
Mainboard IDE Slot
User Manual English
LINDY No. 51024
www.lindy.com
Introduction
The converter IDE TO SATA bridge is a good device to upgrade
your system. This module exchanges the Serial ATA protocol
with Parallel ATA bus transaction. This module has registers that
transfer length and command, and Task File (Shadow registers)
for host bridge functions. This module performs AT-bus
transactions, and supports PIO and UDMA 4 and above.
Feature
- Supports Host to Serial ATA interface.
- Supports 2 channels and 2 devices.
- Dual channels ATA IDE ports to Serial ATA bridge.
- Combining the transport, link and PHY layers of Serial
ATA with a Parallel ATA interface.
- Supports Serial ATA at 1.5Gps (150Mbps) and is
compatible with Ultra ATA 133.
- Accepts Serial ATA commands from the host’s Serial
ATA interface. Decodes the commands and converts
them to Parallel ATA device commands
System Requirements
- Compatibility : Pentium-III, P4, K6, K7 computer
- Windows 98SE/ME/2000/XP/VISTA
Installation
General instructions for installing the adapter are
provided below, (as photo) refer to your computer’s
manual for further information, if needed.
1. Connect the power cable to the adapter (photo 1)
2. Connect the HD and the adapter with SATA
cable.(photo 2)
Photo 1 Photo2
Photo3
3. Connect the adapter to Motherboard IDE drive
(photo 3)
4. Do not forget to connect the power cable to the
hard disk.
Note: No driver is needed to install the Serial ATA-to-
Ultra ATA Adapter. It only acts as a bridge adapter
between Serial ATA and Ultra ATA interface.
Certifications
FCC Certifications
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is
likely to cause harmful interference in which case the user will be
required to correct the interference at their own expense.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received;
including interference that may cause undesired operation.
CE Certification
This equipment complies with the requirements relating to
electromagnetic compatibility, EN 55024 and EN55022 class A for ITE,
EN61000-3-2/-3 the essential protection requirement of Council Directive
89/336/EEC on the approximation of the laws of the Member States
relating to electromagnetic compatibility.
Recycling Information
WEEE (Waste of Electrical and Electronic Equipment),
Recycling of Electronic Products
United Kingdom
In 2006 the European Union introduced regulations (WEEE) for the
collection and recycling of all waste electrical and electronic equipment.
It is no longer allowable to simply throw away electrical and electronic
equipment. Instead, these products must enter the recycling process.
Each individual EU member state has implemented the WEEE
regulations into national law in slightly different ways. Please follow your
national law when you want to dispose of any electrical or electronic
products. More details can be obtained from your national WEEE
recycling agency.
Germany / Deutschland
Die Europäische Union hat mit der WEEE Direktive umfassende
Regelungen für die Verschrottung und das Recycling von Elektro- und
Elektronikprodukten geschaffen. Diese wurden von der Bundesregierung
im Elektro- und Elektronikgerätegesetz – ElektroG in deutsches Recht
umgesetzt. Dieses Gesetz verbietet vom 24.März 2006 an das
Entsorgen von entsprechenden, auch alten, Elektro- und
Elektronikgeräten über die Hausmülltonne! Diese Geräte müssen den
lokalen Sammelsystemen bzw. örtlichen Sammelstellen zugeführt
werden! Dort werden sie kostenlos entgegen genommen. Die Kosten für
den weiteren Recyclingprozess übernimmt die Gesamtheit der
Gerätehersteller.
France
En 2006, l'union Européenne a introduit la nouvelle réglementation
(DEEE) pour le recyclage de tout équipement électrique et électronique.
Chaque Etat membre de l’ Union Européenne a mis en application la
nouvelle réglementation DEEE de manières légèrement différentes.
Veuillez suivre le décret d’application correspondant à l’élimination des
déchets électriques ou électroniques de votre pays.
Italy
Nel 2006 l’unione europea ha introdotto regolamentazioni (WEEE) per la
raccolta e il riciclo di apparecchi elettrici ed elettronici. Non è più
consentito semplicemente gettare queste apparecchiature, devono
essere riciclate. Ogni stato membro dell’ EU ha tramutato le direttive
WEEE in leggi statali in varie misure. Fare riferimento alle leggi del
proprio Stato quando si dispone di un apparecchio elettrico o elettronico.
Per ulteriori dettagli fare riferimento alla direttiva WEEE sul riciclaggio
del proprio Stato.
LINDY No. 51024
www.lindy.com
-
1
-
2
Lindy 51024 Manuale utente
- Tipo
- Manuale utente
- Questo manuale è adatto anche per
in altre lingue
- English: Lindy 51024 User manual
Documenti correlati
Altri documenti
-
Intel D975XBX2 Manuale utente
-
-
-
-
-
-
-
Intel BOXD945PSNLK Manuale utente