CTK38 User Manual
VHF MICROEAR
"DESKTOP" TRANSMITTER
SN: ________________
Rev. 01
Date: 26 February 2018
Rev. 01
CTK38 User Manual
CTK38 User Manual
Rev. 01
2
BRIEF DESCRIPTION
The CTK38 is composed by a VHF transmitter (CST38) and a power supply (PSP910).
The CST
- and many modulation parameters such as deviation, level/frequency
curve, compression factor has been optimized. Therefore CST38 assures maximum
performances of MicroEar both as sound quality and as audio level (in any case limited
because of the very small size of receiver).
Higher power transmitter are available to further increase the coverage area (cell); it is also
possible to link in parallel several transmitters (in iso-frequency mode) to create a multiple
cells coverage.
MicroEar internal battery has about 30 hours working autonomy; in any case the original
battery once activated (taking out metal label) has a limited life even in power off.
When empty battery, MicroEar will drastically reduce audio level and receiver sensitivity.
Example of VHF IEM System
* Not included
AGN00*
MICROEAR
RECEIVER*
CST38
PSP910
Rev. 01
CTK38 User Manual
SAFETY INSTRUCTION
Read this safety instruction and the manual first
Follow all instructions and information.
Do not lose this manual.
Do not use this apparatus under the rain or near the water.
Do not install the apparatus near heaters or in hot environments, do not use outside
the operating temperature range.
Do not open the apparatus, only qualified service technician are enabled to operate on
it. The apparatus needs servicing when it is not properly working or is damaged by
liquids, moisture or other objects are fallen in the apparatus.
Use only accessories or replacement parts authorized or specified by the manufacturer.
Clean the apparatus only with dry cloths, do not use liquids.
Report the serial number and the purchasing date in front of the manual. It is needed to
have proper replacement parts or accessories from the manufacturer.
When replacement parts are needed, use only replacement parts authorized from the
manufacturer. Substitution with not authorized parts could result in electric shock,
hazards or fire.
Keep attention on all the labels with warnings or hazards on the apparatus.
The apparatus is intended for professional use; anyway the manufacturer alerts
the user that the headphone output power of the apparatus could exceed the level of 85
dB(A) of sound pressure level and this could be dangerous for the hearings. Do not use the
headphone with high power level or for long time. Reduce the power or suspend the hearing
in case of any kind of hearing problem.
CTK38 User Manual
Rev. 01
4
FRONT PANEL
1) SELECTOR: modulation audio input level range (Micro / Line).
2) LED INDICATION: peak-indicator / limiter-on status (yellow Led).
3) ADJUSTMENT: audio input sensitivity.
With the optimum sensitivity adjustment, the yellow Led [2] must flash under
modulation peaks.
4) SELECTOR: transmitting channel ( 0 ÷ F ).
5) LED INDICATION: apparatus is on (red Led).
6) SWITCH: On / Off (Power).
Rev. 01
CTK38 User Manual
REAR PANEL
7) CONNECTOR: antenna (N-F type connector).
8) CONNECTOR: modulation audio input (XLR3-F type connector).
The audio input line is transformer balanced and floating.
pin 1 = ground; pin 2 = AF-a input; pin 3 = AF-b input.
9) - 6.3 mm, standard jack
type).
The transmission is allowed when the central pin (hot) is connected to external ring
(ground).
Note #1: in the standard version of CST 38, when the PTT plug is not inserted, the carrier
is still activated.
Instead, when the CST 38 is provided with the optional VOX 38 Voice Activated Circuit
board, the carrier is activated automatically only when the input audio-signal reaches the
activation-threshold pre-set in the VOX 38 board. However, the external PTT circuit (if
connected) can override the VOX 38 device and force the CST 38 in continuous
transmission.
10) CONNECTOR: dc power input (10.5 ÷ 16 Vdc).
( pin 1 = +Vdc, pin 2 = ground).
CTK38 User Manual
Rev. 01
6
OPTIONAL
VOX 38 - Voice Activated Circuit board
This device is useful to switch on automatically the carrier of the transmitter only when the
circuit is mounted on a printed-circuit
board, that has to be factory-mounted in the transmitter.
Once the modulation audio signal reaches the pre-set threshold, the transmitter is
activated.
When the modulating audio signal is not more present, the carrier is switched off again,
after a pre-set delay time. Consequently the relevant MicroEar receiver is muted by its
built-in squelch circuit, preventing the listening of unwanted noise.
Two pre-setting values can be adjiusted by means of relevant screwdriver-trimmers
situated on the printed-
VOX 38 board, mounted
on the CST 38 main board
Rev. 01
CTK38 User Manual
TECHNICAL SPECIFICATIONS
Switchable channels : 16, preset in the 140 ÷ 250 MHz range (other upon request).
Switching-window : 10 MHz (other upon request).
Frequencies : microprocessor controlled PLL synthesizer circuit, with 25 kHz
minimum step [1].
32
Channel spacing : 25KHz standard (Other on request)
Frequency error : < ±5 ppm, in the rated temperature range.
Temperature range : -10 ÷ +55 °C.
RF output power : 300 ÷ 10 mW ( 1 dB) [1].
RF output impedance : 50 ohm (type N-F connector).
Spurious emissions : < 2 nW.
Transmission activation : remote PTT (Push To Talk) circuit, wired to
jack connector.
The transmission is allowed when the central pin (hot) is
connected to external ring (ground). See Note #1 on front
page.
Modulation : FM (peak deviation = ±5 kHz).
Mod. audio input : transformer balanced, floating.
Mod. audio input level : Micro / Line switchable, and externally adjustable between:
Micro = -64 ÷ -34 dBu (0.5 ÷ 15 mV)
- Input impedance = > 2 Kohm
Line = -22 ÷ +8 dBu (60 ÷ 1,950 mV)
- Input impedance = > 10 kohm.
Peak-limiter : automatic, with dynamic-range > 30 dB over the level set for
the nominal modulation.
NR system : compressor circuit with noise-gate, specially adapted to the
MicroEar receivers.
AF bandwidth : 200 Hz ÷ 5 kHz (-3 dB).
Distortion : < 0.5 % (0.25% typ.).
SND/N ratio : > 80 dB (83 dB typ.), CCITT measured.
Led indications : Transmitter On (red LED)
Limiter On (yellow LED).
Powering : 10.5 ÷ 16 Vdc, 300 mA max. (negative ground).
Dimensions : 40 x 120 x 175 mm.
Weight : 700 g ca.
NOTE [1]:
according to local regulations
CTK38 User Manual
Rev. 01
8
Rev. 01
CTK38 User Manual
ITALY ONLY
Obblighi di informazione agli utilizzatori
Modello di informazioni agli utenti dei prodotti di tipo “professionale”
INFORMAZIONE AGLI UTENTI
200
sulla sua confezione indica che il prodotto alla fine della propria vita
utile deve essere raccolto separatamente dagli altri rifiuti.
La raccolta differenziata della presente apparecchiatura giunta a fine
disfarsi della presente apparecchiatura dovrà quindi contattare il
produttore e seguire il sistema che questo ha adottato per
vita.
sivo d
trattamento e allo smaltimento ambientalmente compatibile contribuisce ad evitare possibili effetti
impiego e/o riciclo dei materiali di cui è composta
-
ministrative previste dalla normativa vigente.
CTK38 User Manual
Rev. 01
10
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
in altre lingue
- English: WisyCom CST38 User manual
Documenti correlati
-
WisyCom MRK960 Manuale utente
-
-
-
-
-
-
-
-
-