IMPORTANT: Never add the detergent to the boiler tank. If using the measure and/or funnel with detergent,
always clean them thoroughly before using them to fill the boiler tank.
IMPORTANT: Use the detergent provided (⑪) or a detergent expressly made for use with “steam cleaners”.
Never, under any circumstances, use cleaning agents containing the following: chlorine, solvents, ammonia or
substances marked with an “X”
. Always ventilate the area after using cleaning agents.
Close the cap (I) tightly, pressing it all the way down.•
Press the detergent dispenser button (P) on the gun (M); the detergent will only be dispensed when the button is released • (
6
).
The detergent does not come out immediately; it is necessary to wait for a few seconds. When using for the first time only, •
press the button (P) several times to feed the detergent into the dispenser circuit. In this case, prepare a special container
to capture it.
Only use small amounts of detergent and even then, only when there are particularly stubborn stains; excessive amounts •
of detergent can damage the surface being cleaned. The steam from the appliance is sufficient for normal cleaning.
Use the steam dispenser button (O) and proceed to clean the surface.•
To clean the detergent reservoir (H), operate the dispenser pump (P) until the reservoir is completely empty, or remove the •
cap (I) from the reservoir and tilt the appliance to one side.
ATTACHMENTS
Extension nozzle ①
With this attachment it is possible to thoroughly clean all those surfaces where stubborn dirt can take hold.
The nozzle can be fitted directly to the gun nozzle (E) or extension tubes ⑧: after lining up the marks on the gun nozzle (E)
and attachment, turn the nozzle 90° clockwise until it locks into place (
7
).
Hood ②
This attachment can be fitted to the gun nozzle (E) to protect the end.
Round brush ③
This attachment is for fitting on the extension nozzle ① and helps to dissolve the most stubborn dirt build up, such as the
type that forms on the cook top or in the grout widths between tiles. It can be used to clean bathroom fixtures, sinks, cooker
racks, showers and baths, where it removes all traces of scale (
8
).
Angled nozzle ④
This attachment can be fitted to the gun nozzle (E) after inserting the cap ② or extension nozzle ①.
It is particularly useful for reaching and sterilising difficult areas, where dirt can build up unseen, on radiators, shutters, and
bathroom fixtures, removing it simply and quickly (
9
).
Upholstery brush ⑤
The fabric brush can be fitted straight onto the gun nozzle (E) or to the extension tubes ⑧. When the handy cloth ⑭ is fitted,
it is possible to use the brush to remove dust and for daily cleaning of sofas, armchairs, blankets, mattresses and cushions
(
10
). The brush can also be used to freshen up fabrics, removing all creases. In any case, we recommend, when using
for the first time and during normal use, to discharge the condensation from the steam into a container so as not to wet the
fabrics (
11
).
Window brush ⑥
A window wiper brush can be fitted to the fabric brush ⑤: to assemble the two, just insert the tabs at the base of the fabric brush
into the hooks at the bottom of the window wiper brush. Use the window wiper to restore the polished shine to windows, mirrors
and gloss surfaces. It is also easy to use on shower cubicle glass, removing the problem of lime scale (
12
).
Floor brush ⑦
This accessory is used on extension tubes ⑧ and it has handy cloth grips that can hold, as well as the cloth provided ⑬, any
type of machine washable cloth. To fit the cloth, place the brush in the middle, lift the clips at the ends of the brush, insert a
flap of cloth and then release the clips (
13
).
Extension tubes ⑧
The extension tubes snap together and can be easily separated by pressing the release button. They are useful for reaching
high surfaces with the window wiper ⑥, using the special extension joint, or they can be used with the floor brush ⑦ (
14
).
Attachment bag ⑨
The appliance comes with a bag for the attachments, which is handy for storage as well as for keeping them close at hand.
FILLING THE BOILER TANK DURING USE
If the boiler tank should become empty during use, switch off the appliance, unplug it from the mains power and proceed as
follows:
press the steam dispensing button (O) to discharge any residual steam;•