Buffalo CR836 Manuale del proprietario

Categoria
Frullatori
Tipo
Manuale del proprietario
Model • Modèle • Modell • Modello • Modelo • Malli:
CR836/DR825
Blender
Instruction manual
2
UK Telephone Helpline: 0845 146 2887
Safety Tips
• Position on a flat, stable surface.
• A service agent/qualified technician should carry out
installation and any repairs if required. Do not remove any
components on this product.
• Consult Local and National Standards to comply with the
following:
- Health and Safety at Work Legislation
- BS EN Codes of Practice
- Fire Precautions
- IEE Wiring Regulations
- Building Regulations
• DO NOT use jet/pressure washers to clean the appliance.
• DO NOT immerse the appliance in water.
• This appliance is only used for blending food. Do not use the
appliance for anything other than its intended use.
• Always switch off and disconnect the power supply to the
appliance when not in use.
• Not suitable for outdoor use..
• Keep all packaging away from children. Dispose of the
packaging in accordance to the regulations of local authorities.
• If the power cord is damaged, it must be replaced by an
BUFFALO agent or a recommended qualified technician in
order to avoid a hazard.
• This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been
given supervision or instruction concerning the use of the
appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not play
with the appliance.
3
UK
Telephone Helpline: 0845 146 2887
• Do not let cord hang over edge of table or counter, or touch
hot surfaces.
• Keep hands and utensils out of the jug while motor is running
to prevent severe personal injury and / or damage to the
blender.
Blade is sharp – handle carefully.
• Never try to remove blade while jug is sitting on the blender
base.
• Do not operate with loose or damaged blades.
• Do not place jug on to base with On/Off switch in the On
position.
• Always operate with lid in place.
• Do Not blend Hot Liquids.
• Do not leave blender unattended while in use.
• Buffalo recommends that this appliance should be periodically
tested (at least annually) by a Competent Person. Testing
should include, but not be limited to: Visual Inspection,
Polarity Test, Earth Continuity, Insulation Continuity and
Functional Testing.
Introduction
Please take a few moments to carefully read through this manual. Correct maintenance and operation of
this machine will provide the best possible performance from your BUFFALO product.
Product Description
CR836 - Buffalo Blender - 2.5L Jug
DR825 - Buffalo Blender - 2.5L Jug with Sound Enclosure
Pack Contents
The following is included:
BUFFALO Blender
Blender Jug, lid and lid plug
Food pusher
Instruction manual
BUFFALO prides itself on quality and service, ensuring that at the time of packaging the contents are
supplied fully functional and free of damage.
Should you find any damage as a result of transit, please contact your BUFFALO dealer immediately.
4
UK Telephone Helpline: 0845 146 2887
Operation
Model: CR836 Model: DR825
Lid plug
Lid
Jug
Sound
Enclosure
Pulse switch
On/Off switch
Variable Speed Dial
Food
pusher
Controls
On/Off switch: Up for On (I), down for Off (0)
Variable Speed Dial: Allows continual adjustment of speed from low to high
Pulse Switch: Down to pulse at high speed
Blending
Before use, ensure to
Clean all removable parts thoroughly.
Turn off On/Off switch (0 position).
1. Plug in Blender.
2. Place ingredients into blender.
3. Secure the lid and lid plug (Note: Always operate with the lid secured).
4. Locate jug on to body of blender.
5. Select speed using variable speed dial.
6. Turn on blender using On/Off switch.
7. Using the pulse function: Set the Pulse switch to I position and hold to start pulse function.
Release to stop.
5
UK
Telephone Helpline: 0845 146 2887
Note: When blending dry ingredients best results will be obtained by cutting
ingredients into small pieces and adding to the blender through the hole in the
lid when motor is running.
Note: Before removing jug, ensure to turn off blender using On/Off switch and
let the motor come to a complete stop.
Cleaning, Care & Maintenance
Always disconnect from power supply before cleaning.
Always allow to cool before cleaning.
Let the motor come to a complete stop before removing the jug.
The jug is NOT dishwasher proof!
Use warm, soapy water and a damp cloth to clean the jug.
Warning: Blade is sharp - handle with care.
Dry thoroughly after cleaning.
A BUFFALO dealer or qualified technician should carry out repairs if required.
Warning: Do not allow any water to spill into the body of the appliance when
cleaning.
Troubleshooting
Fault Probable Cause Solution
The unit is not
working
The unit is not switched on Check the unit is plugged in correctly and
switched on
Plug and lead are damaged Call BUFFALO agent or qualified Technician
Fuse in the plug has blown Replace the plug fuse
Power supply Check power supply
Internal wiring fault Call BUFFALO agent or qualified technician
Jug incorrectly located on body of
appliance
Relocate Jug
6
UK Telephone Helpline: 0845 146 2887
Technical Specifications
Model Voltage Power Current Jug
Capacity
Dimensions
h x w x d mm Weight
CR836 220-240V
50/60Hz
1680W 8A 2.5L 535 x 236 x 253 5.9kg
DR825 220-240V
50/60Hz
1680W 8A 2.5L 547 x 236 x 253 8.9kg
Electrical Wiring
This appliance is supplied with a 3 pin, moulded, BS1363 plug and lead, with a 13 amp fuse as standard.
The plug is to be connected to a suitable mains socket.
This appliance is wired as follows:
Live wire (coloured brown) to terminal marked L
Neutral wire (coloured blue) to terminal marked N
Earth wire (coloured green/yellow) to terminal marked E
This appliance must be earthed.
If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency
disconnection being required they must be readily accessible.
Compliance
The WEEE logo on this product or its documentation indicates that the product must
not be disposed of as household waste. To help prevent possible harm to human
health and/or the environment, the product must be disposed of in an approved and
environmentally safe recycling process. For further information on how to dispose of
this product correctly, contact the product supplier, or the local authority responsible for
waste disposal in your area.
BUFFALO parts have undergone strict product testing in order to comply with regulatory
standards and specifications set by international, independent, and federal authorities.
BUFFALO products have been approved to carry the following symbol:
All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic,
mechanical, photocopying, recording or otherwise, without the prior written permission of BUFFALO.
Every effort is made to ensure all details are correct at the time of going to press, however, BUFFALO reserve the right to
change specifications without notice.
DECLARATION OF CONFORMITY
Conformiteitsverklaring Déclaration de conformité Konformitätserklärung Dichiarazione di conformità
Declaración de conformidad Declaração de conformidade
Equipment Type Uitrustingstype • Type d'équipement
Gerätetyp Tipo di apparecchiatura Tipo de equipo Tipo de
equipamento
Blender -2.5Ltr Jug
Blender -2.5Ltr Jug -with Sound Enclosure
Blender with Touch Control -2.5Ltr Jug
Blender with Touch Control -2.5Ltr Jug -with Sound
Enclosure
Model Modèle Modell Modello Modelo Malli
CR836,DR825,CY140,CY141
Application of Council Directives(s)
Toepassing van Europese Richtlijn(en) • Application de la/des
directive(s) du Conseil Anwendbare EU-Richtlinie(n) •
Applicazione delle Direttive • Aplicación de la(s) directiva(s) del
consejo Aplicação de directiva(s) do Conselho
Machinery Directive 2006/42/EC
EN 60204-1: 2006 +A1:2009/AC2010
EN ISO 12100:2010
EN 12852:2001 +A1:2010
Electro-Magnetic Compatibility (EMC) Directive
2014/30/EU
EN 55014-1: 2006 +A1:2009+ A2:2011
EN 55014-2:2015
EN 61000-3-2:2014
EN 61000-3-3:2013
Restriction of Hazardous Substances Directive
(RoHS) 2015/863 amending Annex II to Directive
2011/65/EU
Producer Name Naam fabrikant Nom du producteur Name
des Herstellers Nome del produttore Nombre del fabricante
Nome do fabricante
Buffalo
Producer Address Adres fabrikant Adresse du producteur
Anschrift des Herstellers Indirizzo del produttore Dirección del
fabricante Morada do fabricante
Fourth Way,
Avonmouth,
Bristol,
BS11 8TB
United Kingdom
42 North Point
Business Park
New Mallow Road
Cork
Ireland
I, the undersigned, hereby declare that the equipment specified above conforms to the above Directive(s) and
Standard(s).
Ik, de ondergetekende, verklaar hierbij dat de hierboven gespecificeerde uitrusting goedgekeurd is volgens de
bovenstaande Richtlijn(en) en Standaard(en).
Je soussigné, confirme la conformité de l'équipement cité dans la présente à la / aux Directive(s) et Norme(s) ci-dessus
Ich, der/die Unterzeichnende, erkläre hiermit, dass das oben angegebene Gerät der/den oben angeführten Richtlinie(n)
und Norm(en) entspricht.
Il sottoscritto dichiara che l'apparecchiatura di sopra specificata è conforme alle Direttive e agli Standard sopra riportati.
El abajo firmante declara por la presente que el equipo arriba especificado está en conformidad con la(s) directiva(s) y
estándar(es) arriba mencionadas.
Eu, o abaixo-assinado, declaro que o equipamento anteriormente especificado está em conformidade com a(s)
anterior(es) Directiva(s) e Norma(s)
Date • Data • Date • Datum • Data • Fecha • Data
17th June 2019
Signature Handtekening • Signature • Unterschrift
Firma • Firma • Assinatura
Full Name Volledige naam • Nom et prénom Vollständiger Name •
Nome completo Nombre completo Nome por extenso
Ashley Hooper
Position Functie Fonction • Position • Qualifica Posición Função
Technical & Quality Manager
CR836_DR825_UK_A5_v2_20190618
http://www.buffalo-appliances.com/
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

Buffalo CR836 Manuale del proprietario

Categoria
Frullatori
Tipo
Manuale del proprietario