Model:
CT931-A
Crepe Maker
Instruction manual
2
EN Telephone Helpline: 1300225960
Safety Instructions
• Position on a flat, stable surface.
• A service agent/qualified technician should carry out
installation and any repairs if required. Do not remove any
components on this product.
• Consult Local and National Standards to comply with the
following:
- Health and Safety at Work Legislation
- Fire Precautions
- Wiring Regulations
- Building Regulations
• Caution! Hot surface! Do not touch!
The temperature of cooking surface maybe high when the
appliance is operating.
• DO NOT immerse the appliance in water.
• DO NOT clean with jet/pressure washers.
• DO NOT move or carry the appliance when it is switched on.
• DO NOT leave the appliance unattended during operation.
• Always use oven gloves when cooking or carrying out any
adjustments to the appliance.
• Do not obstruct any ventilation openings in the appliance
body.
• During and after cooking, the unit is still hot. Never touch the
surface to avoid scalding.
• Always switch off and disconnect the power supply to the
appliance when not in use.
• This appliance must only be used in accordance with these
instructions and by persons competent to do so.
• Keep all packaging away from children. Dispose of the
packaging in accordance to the regulations of local authorities.
3
EN
Telephone Helpline: 1300225960
• If the power cord is damaged, it must be replaced by an
Apuro agent or a recommended qualified technician in order
to avoid a hazard.
• This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been
given supervision or instruction concerning the use of the
appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not play
with the appliance.
• Apuro recommend that this appliance should be periodically
tested (at least annually) by a Competent Person. Testing
should include, but not be limited to: Visual Inspection,
Polarity Test, Earth Continuity, Insulation Continuity and
Functional Testing.
Introduction
Please take a few moments to carefully read through this manual. Correct maintenance and operation of
this machine will provide the best possible performance from your Apuro product.
Pack Contents
The following is included:
• Apuro Crepe Maker
• Instruction manual
Apuro prides itself on quality and service, ensuring that at the time of packaging the contents are
supplied fully functional and free of damage.
Should you find any damage as a result of transit, please contact your Apuro dealer immediately.
Installation
• Place the unit on a heat-resistant surface. Avoid placing it on or close to flammable materials.
Maintain a distance of 20cm (7 inches) between the appliance and walls or other objects for
ventilation.
• Keep the unit away from splashing water and countertop’s edge.
Note: Before using for the first time, clean the appliance with warm soapy
water. Let dry completely.
4
EN Telephone Helpline: 1300225960
Operation
Storage tray
Hot plate
HEAT Indicator light
POWER Indicator light
Thermostat
Making Crepes
1. Connect the appliance to the mains power supply.
The POWER indicator light (green) turns on.
2. Set the thermostat to the desired temperature
(50°C-300°C). The HEAT indicator light (orange)
turns On and the appliance begins to heat up.
3. When the set temperature is reached, the HEAT
indicator light turns Off.
4. Pour the required amount of batter mixture on to
the hot plate.
5. Spread the mixture in a circular motion around the
hotplate with a spreader [Fig. 1].
6. Cook on one side before flipping with a spatula to
cook the other side of the crepe.
7. Turning off: After use, set the thermostat to OFF
position and disconnect the appliance from power
supply.
1
5
EN
Telephone Helpline: 1300225960
Overheating protection
This appliance is featured with an overheat protection. Should the temperature exceed safe levels the
appliance will automatically cut off power.
The thermal Cut-out switch is located on the rear of the appliance. To reset the appliance after a sufficient
cool-down period:
1. Unscrew the reset switch cover.
2. Press the small reset switch down until it clicks, using a blunt pointed instrument.
3. The appliance is now reset and can be used as normal.
Cleaning, Care & Maintenance
Always switch off the appliance, disconnect the power supply and allow to cool
before cleaning or performing maintenance.
• If necessary wipe the exterior with a soft cloth and warm soapy water.
• Dry thoroughly after cleaning.
Troubleshooting
A qualified technician must carry out repairs if required.
Fault Probable Cause Solution
The unit is not
working
The unit is not switched on Check the unit is plugged in correctly and
switched on
Plug or lead is damaged Replace plug or lead
Mains power supply fault Check mains power supply
Overheating protection is activated Reset the appliance
Technical Specifications
Model Voltage Power Current
Cooking
Surface
Diameter
Temperature
Range
Dimensions
h x w x d mm Weight
CT931-A 220-240V~
50Hz-60Hz
3000W 13A 400mm 50ºC-300ºC 220 x 450 x 470 20.5Kg
Note: Due to our continuing program of research and development, the specifications herein may subject
to change without notice.
6
EN Telephone Helpline: 1300225960
Electrical Wiring
The plug is to be connected to a suitable mains socket.
This appliance is wired as follows:
• Live wire (coloured brown) to terminal marked L
• Neutral wire (coloured blue) to terminal marked N
• Earth wire (coloured green/yellow) to terminal marked E
This appliance must be earthed.
If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency
disconnection being required they must be readily accessible.
Compliance
The product must not be disposed of as household waste. To help prevent possible harm to human
health and/or the environment, the product must be disposed of in an approved and environmentally safe
recycling process. For further information on how to dispose of this product correctly, contact the product
supplier, or the local authority responsible for waste disposal in your area.
Apuro parts have undergone strict product testing in order to comply with regulatory
standards and specifications set by international, independent, and federal authorities.
Apuro products have been approved to carry the following symbol:
All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic,
mechanical, photocopying, recording or otherwise, without the prior written permission of Apuro.
Every effort is made to ensure all details are correct at the time of going to press, however, Apuro reserve the right to
change specifications without notice.
DECLARATION OF CONFORMITY
• Conformiteitsverklaring • Déclaration de conformité • Konformitätserklärung • Dichiarazione di conformità •
• Declaración de conformidad • Declaração de conformidade
Equipment Type • Uitrustingstype • Type d'équipement • Gerätetyp
• Tipo di apparecchiatura • Tipo de equipo • Tipo de equipamento
Model • Modèle • Modell • Modello
• Modelo • Malli
Crepe Maker
CT931-A
Application of Territory Legislation &
Council Directives(s)
Toepassing van Europese Richtlijn(en) •
Application de la/des directive(s) du
Conseil • Anwendbare EU-Richtlinie(n) •
Applicazione delle Direttive
• Aplicación de la(s) directiva(s) del
consejo • Aplicação de directiva(s) do
Conselho
Electrical safety
IEC 60335-1:2010: +A1:2013 +A2:2016
IEC 60335-2-38:2002 +A1:2008
EN 62233:2008
Electro-Magnetic Compatibility
EN 55014-1:2017
EN 55014-2:2015
EN IEC 61000-3-2:2019
EN 61000-3-3:2013 +A1:2019
Producer Name • Naam fabrikant • Nom du producteur • Name des Herstellers
• Nome del produttore • Nombre del fabricante • Nome do fabricante
Apuro
I, the undersigned, hereby declare that the equipment specified above conforms to the above Territory Legislation, Directive(s)
and Standard(s).
Ik, de ondergetekende, verklaar hierbij dat de hierboven gespecificeerde uitrusting goedgekeurd is volgens de bovenstaande
Richtlijn(en) en Standaard(en).
Je soussigné, confirme la conformité de l'équipement cité dans la présente à la / aux Directive(s) et Norme(s) ci-dessus
Ich, der/die Unterzeichnende, erkläre hiermit, dass das oben angegebene Gerät der/den oben angeführten Richtlinie(n) und
Norm(en) entspricht.
Il sottoscritto dichiara che l'apparecchiatura di sopra specificata è conforme alle Direttive e agli Standard sopra riportati.
El abajo firmante declara por la presente que el equipo arriba especificado está en conformidad con la(s) directiva(s) y
estándar(es) arriba mencionadas.
Eu, o abaixo-assinado, declaro que o equipamento anteriormente especificado está em conformidade com a(s) anterior(es)
Directiva(s) e Norma(s)
Date • Data • Date • Datum • Data •
Fecha • Data
1st June 2021
Signature • Handtekening • Signature
• Unterschrift Firma • Firma •
Assinatura
Full Name • Volledige naam • Nom et
prénom • Vollständiger Name • Nome
completo • Nombre completo • Nome
por extenso
Ashley Hooper
Josie Holt
Position • Functie • Fonction • Position
• Qualifica • Posición • Função
Technical & Quality Manager
Commercial Manager/ Responsible
Supplier
Producer Address • Adres fabrikant •
Adresse du producteur • Anschrift des
Herstellers • Indirizzo del produttore •
Dirección del fabricante • Morada do
fabricante
Fourth Way,
Avonmouth,
Bristol,
BS11 8TB
United Kingdom
15 Bagdally Road,
Campbelltown
NSW 2560
DocuSign Envelope ID: E56384ED-0A57-4AE7-A8D6-2199030D2CFC
CT931-A_A5_v3_2022/08/23
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
in altre lingue
- English: APURO CT931-A User manual
- français: APURO CT931-A Manuel utilisateur
